YOU ARE BIDDING ON A PAIR OF -16an STAINLESS STEEL BRAIDED BMRS RETURN HOSES FOR AUTO VERDI DRY SUMP OIL PUMPS FROM A LEADING NASCAR TEAM. 

BROWN & MILLER -16an STAINLESS STEEL BRAIDED PTFE CORE HOSE

THIS IS THE SQUARE 4 BOLT FITTING THAT GOES ON THE REAR OF THE PUMP AND THE TOP OF THE PUMP FOR THE RETURN LINES BACK TO THE TANK

THE LINE THAT COMES OFF THE TOP OF THE PUMP IS APPROX 22.5" FROM END OF THE ADAPTER FITTING TO CENTER OF THE 4 BOLT END

THE LINE THAT COMES OFF THE BACK OF THE PUMP IS APPROX 16" FROM END OF THE ADAPTER FITTING TO CENTER OF THE 4 BOLT END

ALL MEASUREMENTS STATED ARE +/- 1" DEPENDING ON HOW YOU HOLD THE TAPE AND WHERE YOU START / END FROM 

INCLUDES ADAPTER FITTINGS ON THE ONE END THAT TRANSITION THESE HOSES TO A STANDARD -16an FITTING THREADED HOSE. THESE ADAPTER FITTINGS WERE INSTALLED WITH NEW O-RINGS INSIDE AND ARE HELD ON BY A SNAP RING.

THE PORT FITTING END UNDER THE ADAPTER FITTINGS MEASURES .998" od ON THE INSERT PORTION AND THE LIP IS 1.417" od.

NORMAL EXTERNAL MARKINGS AND WEAR FROM TYPICAL USE. THE STAINLESS MAY BE DISCOLORED FROM ENGINE HEAT AND HAVE MARKINGS ON THE ANODIZING PORTIONS OF THE FITTINGS. THE STAINLESS MAY OR MAY NOT HAVE MINIMAL PRICKLY SPOTS COMMON WITH STAINLESS BRAIDED HOSES ONCE THEY HAVE BEEN USED IN RACE CONDITION. THEY INCLUDE HEAT SLEEVES IF SHOWN IN THE PICTURES. IF NOT SHOWN THEN THEY ARE NOT INCLUDED. YOU CAN CUT THEM OFF WITH A UTILITY KNIFE IF YOU HAVE NO USE FOR THEM.

INCLUDES 2 TOTAL NEW -022 SIZE O-RINGS THAT GO ON THE 4 BOLT FITTING ENDS

YOU ARE BUYING THE EXACT HOSES PICTURED IN THE EXACT CONDITION SHOWN - NO FILE PHOTOS.

THE ANODIZED FITTINGS MAY HAVE WEAR, SCRATCHES, GOUGES, ETC. WILL BE SHOWN IN CLOSE UP PICTURES IF APPLICABLE.

INVENTORY #526-678

CONDITION: USED