NEWLY BUILT VELLEMAN  K7000 SIGNAL TRACER/INJECTOR KIT IN CASE.

THE K7000 KIT WAS MADE BY MYSELF AND PUT IN CASE WITH THE FOLLOWING ADDED.

- CASE
- SPEAKER
- ON/OFF SWITCH
- POWER ON LED
- BATTERY CONNECTOR
- BRAND NEW BATTERY
- BANANA CONNECTORS - FOR CONNECTING TO UNIT UNDER TEST
- KNOBS FOR VOLUME CONTROL
- 2 PROBES

THE CASE IS MY OWN DESIGN AND BUILD. ALL THE PARTS ARE NEW.

FYI - THE KIT ITSELF DOES NOT COME WITH ALL THE PARTS YOU NEED TO MAKE A WORKING UNIT. THERE IS NO SPEAKER, NO ON/OFF SWITCH, NO BATTERY, NO BATTERY CONECTOR AND NO MEANS TO CONNECT THE UNIT UNDER TEST TO THE SIGNAL TRACER NOR THE SIGNAL INJECTOR - THATS WHAT YOU GET WITH THE CASE AND ITS PARTS.

THE FINISHED KIT PLUS THE CASE AND ITS PARTS WILL GIVE YOU A COMPLETE WORKING UNIT IN A NICE CASE. 

PLEASE NOTE - THE UNIT WILL SHIP WITH THE BATTERY UNPLUGED. YOU WILL NEED TO OPEN THE CASE (4 SCREWS) PLUG CABLE IN, CLOSE CASE AND YOUR READY TO GO.

I WILL ALSO INCLUDE A PRINT OUT THE MANUAL ON 8.5 X 11 PAPER + CHARTS ON THE MODIFICATION + A SET OF 2 NEW LEADS + A WATERPROOF SEAL FOR THE CASE + THE EMPTY BOX OF THE KIT 

LOW $3.99 FLAT RATE SHIPPING COST TO USA ADDRESSES ONLY. 

SIGNAL TRACER/INJECTOR SPECS

This signal tracer /injector has been designed to inject or detect a specific signal into an audio circuit in need of repair (such as amplifiers, radios, tone controls, ...) so as to detect the fault. In this way problems can be traced more easily. The signal tracer may also be used as a simple monitor or amplifier.

Features
  • signal injector:
        ·0-2.5Vrms output (adjustable)
        ·Output impedance: 1.5Kohm
        ·frequency: ± 1kHz
  • signal tracer:
        ·3.5mV to 10Vrms sensitivity (adjustable)
        ·gain: 40dB
        ·input impedance: 50Kohm
  • output power: 0.5W / 8ohm
  • power supply: 7-9V AC or 9-12V DC / 150mA
  • dimensions: 2.4 x 2.1"