Specification:
Spray Gun Material: Aluminum Alloy
Cup Material: PVC
Fluid Nozzle: 1.4mm, 1.7mm, 2.0mm
Air Consumption: 14.5CFM
Operating Pressure: 15-43 psi / 1-2.96 Bar
The Best Fine Atomization Pressure: 20-30 psi
Pattern Width: 160-240mm
Hopper Size: 10CM Diameter
Air Inlet: 1/4 inch
Cup Capacity: 600cc
Air Pressure Regulator: 0-180 psi
Features:
1.All Copper Flow Cap
All copper flow cap, metal valve core, wear-resistant and corrosion-resistant, 15 hole design, fine atomization.
2.Needle Tip Details
After special treatment, the sealing function is good and the service life is long.
3. Durable aerosol can
Use high quality PVC material, durable and fall resistant, clear scale, long service life and convenient cleaning. 600cc PVC cup allows viewing of paint fluid level.
4. Flow Spray Range Regulating Valve
Slip resistant design, adjustable tightness
Flow regulating valve (Loosening: More paint output, Tightening: Less paint output)
Package Include:
1 x Spray Gun Set
or 1 x 3 Nozzle
Spray gun cleaning method:
At the end of each day's work, clean the spray gun with water. The cleaning method is as follows: let Tianna water or spray gun water spray out from the gun body like oil spray. Repeat the operation. After cleaning, close the paint and dry it by hanging. Every other week, the needle nozzle and atomizing cap need to be removed, then soaked in Tianna water, cleaned, dried, applied with a little pneumatic oil, and then installed into the spray gun. Note that the nozzle interface is wrapped with white sealing tape to ensure the airtightness of the spray gun. If the viscosity of high spray paint, two or three days can be operated once. If the paint is properly maintained, it will increase its service life and maximize its value.
Note:
1. Please allow 1-3mm error due to manual measurement. please make sure you do not mind before you bid.
2. Due to lighting effects, monitor's brightness contrast settings etc, there could be some slight differences in the color tone of the pictures and the actual item!