[Usage Instructions]:
1.Preparation: Clean hands and wear thin-film gloves. Select an
appropriate tray and ensure a 3-4 mm gap between the tray and
the teeth.
2.Initial Impression: Use Heavy-body Type 0. Mix base and
catalyst in a 1:1 volume ratio,knead into a strip, fill the tray groove,
3.Trim Initial Impression: Use a trimming knife to refine the
have the patient bite for three minutes, then remove and trim.
impression and prepare for the secondary impression.
4.Secondary Impression: Load Light-body into the dispensing gun.
To avoid uneven mixing, discard the initial portion of the Light-body.
Evenly inject it into the initial impression tray groove.
5.Curing and Removal: Place the Light-bodyimpression into the
mouth,reposition to the bite alignment,wait three minutes
for curing, then remove.
1.Base(impression putty) *400g
2.Catalyst*400g
3.Spoons for retaking (One pair)
4.Packing Box
5.User Manual
FDA Statement
The sale of this item may be subject to regulation by the U.S. Food and Drug Administration and state and local regulatory agencies.
If so, you can bid on this item only if you are an authorized purchaser.
If the item is subject to FDA regulation, I will verify your status as an authorized purchaser of this item before shipping of the item.