1.Product Configuration
Main control box : 1 pcs
Start/stop button : 1pcs
Engine Start universal wire : 1pcs
Control Wire : 1pcs
Bluetooth and solder wire
2. Features
The system can learn the original car remote control lock/unlock function as arm/disarm,
When disarmed by original remote control, the car can be started by the engine start button,after armed, the car can’t be started .
Remote engine start function by original remote controller.
Note :
Need leave an original ignition chip in the car if the car with engine anti-theft function.
3. Function introduction
3.1 Use the original car remote control, to active the system arm/disarm
It need connect lock /unlock positive signal wire for arm/disarm by original remote controller
3.2 Arm
After lock button pressed , the LED light in the push button will flash once , the system will arm , the engine can’t start.
3.3 Disarm
After unlock button pressed , the LED light in the push button will flash twice, the system will disarm , the engine can start
3.4 Engine one-key Start
One key start: Step on the foot brake, press the button,the engine will be started。
3.5 Engine off
Step on the foot brake, press the key again ,the engine will be off。
3.6 Turn on ACC, ON
Don’t step on the foot brake, Press the key one time, ACC is turned on, press the key again ,ON is turned on,and if press the key again, ACC ,ON will be turned off
3.7 Remote start
Press the lock button of the original remote controller 5 times in 5 seconds, the engine will be started.
4.How many wires need to be connected ?
4.1It need connect +12V, ACC, ON1, ON2, START and GND wires , and if don’t want connect these wires , please buy special ignition cable from our store or contact us to buy special product.
4.2Connect brake wire, if don’t connect brake wire, it can do start/stop by press the button 2 seconds.
4.3For standard product , it need connect lock positive signal and unlock positive signal, to detect arm or disarm status.
4.4If selects Bluetooth or NFC options , no need connect lock positive and unlock positive signal.
It can use APP , NFC card or phone NFC to do arm and disarm , and it also can activate bluetooth keyless entry function, the device will arm or disarm automatically when you take smart phone leave or close to the car.
4.5If select Bluetooth or NFC module , there is a soldering cable for soldering original remote controller , so APP ,NFC or Bluetooth keyless entry function can do lock, unlock and trunk by control original remote controller.No need cut wires to install .
4.6After remote started, our device will lock the door automatically ,but original remote controller will not work when engine starting , so there are three methods to solve it :
A.Use metallic key blade to open the door
B.Sets function jumper to activate auto-stop function when use APP lock or unlock.
When use APP to do lock or unlock after remote started , it will stop engine, then original remote controller can work again. The device can control it to unlock or lock .
C.Connects reserved central locking wires to the vehicle : unlock- and lock- .