✅【5 MICRON FILTRATION】Premium 5-micron filter media effectively removes contaminants, water and impurities. Meets or exceeds OEM specifications for optimal fuel flow.
✅【COMPLETE KIT】Direct Replacement For FD-4615, BC34-9N184-BA, BC3Z-9N184-B, L4615F, 33615, FF1223, K10826, BF9895.
✅【LEAK-PROOF DESIGN】Precision-engineered O-rings ensure tight seal. Premium rubber material prevents fuel leaks. Tested for durability under harsh conditions.
✅【Package includes】6 Packs (1 Pack includes Two filters: one engine mounted filter and the frame mounted filter, and one gasket/o-ring for the frame mounted filter).
COMPATIBLE WITH
For 2011-2016 F-250 Super Duty 6.7L Diesel Engine
For 2011-2016 F-350 Super Duty 6.7L Diesel Engine
For 2011-2016 F-450 Super Duty 6.7L Diesel Engine
For 2011-2016 F-550 Super Duty 6.7L Diesel Engine
For 2016 F-650 Base Straight/Tractor Truck 6.7L Diesel Engine
For 2016 F-750 Base Straight/Tractor Truck 6.7L Diesel Engine
Precision Filtration:
Our advanced media traps 5-micron contaminants, ensuring clean fuel.
Water Warrior:
Efficiently separates 98% of water from your fuel, preventing rust and injector tip failure.
Frame-Mounted Filter Change:
1: Disconnect the electrical sensor harness.
2: Open the yellow drain valve and drain fuel into a container.
3: Use a strap wrench (recommended) or 11/4"socket to loosen and remove the filter cap.
4: Replace the filter and lubricate the new O-ring before reassembly
Engine-Mounted Filter Change:
1: Release the fuel line clips (push yellow tabs /squeeze white tabs).
2: Twist the filter housing to the right until it stops, then pull straight up to remove.
3: Install the new filter and reassemble in reverse order.
Perfect connected plastic module will not be separated,excellent tightness.The fuel line and the buckle towards to the same direction.
Remove sensor harness, and lossen filter housing with a 1 1/4" socket or 32mm or use a strap wrench. I highly recommend a strap wrench so you don't shear the plastic housing. Turn 3 TIMES (before opening the drain valve as to not drench yourself in fuel) then losses yellow drain valve and drain into suitable container. Remember to lube new o-ring and re install everything.
Remove the fuel line keepers on both lines and by pushing down the yellow tabs and the keeper will go down out of the way, the other fuel line will come off by squeezing both white tabs inward then remove. Loosen the 7mm nut use a 7mm socket wrench to loosen the clamp around the filter, twist to the right until it stops then pull upwards, and install following the same steps in reverse order.
When all done with both filters:
You must cycle the key to the on position 6 times waiting approx 30 secs each time before trying to start truck.Turn ignition key to on, but do not start. Wait 30 seconds until the fuel pump times out, then turn the key back to off. Repeat 6 times. You will probably notice strange noises coming from the fuel system until it is mostly full.