Ionizing Air Gun Lonizing Air Blower Handle for Ionizing High Voltage Generator
Product features
Neutralise static electricity quickly Less than 1.3s Ionic airflow covers a large area Good grounding protection within 1m of the air gun
Made of lightweight, durable plastic for electrostatic dust removal. With air strengthening function
Product use:
1: De-electricity and dust removal for products formed by plastic pressing.
2: Removal of electricity and dust from wide products such as automobiles, ships, FRP, etc., woodworking furniture, various kinds of plywood, and cosmetic boards.
Electrostatic dust removal gun
Precautions
1、Read the product manual before installation and operation.
2、The socket connected to the high-voltage power supply must be reliably grounded.
3, flammable and explosive environment may not operate the ionic wind gun.
4、No unauthorised repair.
5, the use of ionic wind gun should be gently held and put.
Maintenance methods
1, power supply, gas source requirements ① power supply must have a ground, and to ensure adequate grounding. Transformer must ensure good grounding, each time before use to check whether the grounding wire knob is tightened. ② The gas used must be effectively filtered. Sometimes a secondary filter is required. The filter should be cleaned in time. Otherwise: particles of water, oil and dust/powder can enter the ion generating chamber and adhere to the inner walls of the plastic parts. Accumulating to a certain level, the ion needle fires on them. As a result, the plastic parts gradually form honeycomb charred damage, while the ion exclusion amount gradually decreases; especially, it creates a safety hazard.
2, in addition to the effect of static electricity adjustment ① in addition to the effect of static electricity in addition to static electricity time and air pressure is inversely proportional. Air pressure should be 0.3Mpa-0.7Mpa. ② gun, wind nozzle head and static field distance, angle affects the effect of static electricity, should pay attention to debugging until satisfied.
3, daily maintenance ① wind gun / nozzle head easy to break. Pay attention to the wind gun to prevent the use of touch, after use, pay attention to the fall. Even if the fixed installation of the nozzle, should also pay attention to prevent the collision of objects. ② wind gun air pressure regulator valve moderate, appropriate amount of points into the universal anti-rust lubricant. ③ Clean the ionic wind gun ion needle and ion needle chamber with anhydrous alcohol can not use Tianna water. Cleaning, the first power off, and then use the camera to the ion wind gun head in front of the small plastic cover (also known as air accelerator) unscrewed, with a cotton swab dipped in anhydrous alcohol to clean the ion needles and ion needles in the interior chamber, will be inside the internal stains, dirt and clean. ④ Ion wind gun to the air is best to add a foot switch, or through the solenoid valve and mechanical action linkage regulation, both to improve the use of the effect, but also to extend the service life.