What are advantages of the product ?
1. Made of high quality ABS plastic, high elasticity and toughness, durable in use.
2. Original standard, direct replacement for old or broken one.
3. Adaptable and compatible, just install and it will work well as the original one.
4. Easy installation without extra adjustment.
5. Exquisite workmanship, be dependable for use and convenient for assembly and disassemble.
How to get the correct part ?
1. Visually compare the part you are replacing with our pictures above.
2. Match a reference number from the Item specifics chart.
3. Identify your vehicle in the Compatibility Table and pay attention to the important part details.
Why need to install a new switch ?
Because of their use, power window switches can fail from time to time. This can be
because it gets wet, wires start to corrode, or it simply wears out. You may be required
to install a new power window switch.
How to Install a Power Window Switch?
Step 1 - Pry off Bezel
Using a flat head screwdriver you can pry up the bezel that the switch is in. You do not have to remove
the door casing or the handle of the door. You simply pry gently on the power window switch bezel to
get at the housing.
Step 2 - Remove from Bezel
Once the bezel comes loose, you will notice some tabs that hold it into place. Press down on the locking
tab and it will come loose. Hold up the switch and bezel and look for some tabs that hold the switch to
the bezel itself. Pry these with a little pressure from the screwdriver and pop the switch from the bezel.
Step 3 - Remove Rockers from Switch
Once you have the power window switch out of the bezel, remove it from the outlet. This is simply
disconnecting it from the wire harness. Remove the rockers from the window switch and make sure that
you know which direction they go when transferring to the new switch.
Mark the front with a small piece of tape so you know where to place them on the new switch.
Step 4 - Assemble New Switch
With the rockers in hand, you can then install them onto the new switch. Take an extra minute to reassure
yourself that you have them facing in the right direction. Remove the tape, if you used any, and then connect
the wires back to the switch. Pop back into the bezel holder and slide the assembly back into the hole in the door.
Push the assembly back in place and make sure you hear the tab snap.
Test out the rockers to see if the switch moves the way that it should.
Step 5 - Test Window
Turn your car on and see if the new power window switch works.
