Software use:
1. RPI firmware and raspi config have been updated for camera. Please perform apt get update; apt get upgrade once;
2. select camera in raspi config, start camera drive in RPI firmware, and restart
3. use command-line programs raspivid and raspistil to operate the camera to capture video clips or images
4. the captured video clip needs to be played with Mplayer
How to broadcast the camera data through Webcast:
The input data of camera is directly redirected to the network port to realize the output by NC command (NCAT - concatenate and redirect sockets)
Here is a detailed description
Parameters:
Lens: 1/45m
Aperture: 2.9
Focal length: 3.29
Field of view angle: 72.4 degrees
Hardware connection:
1. soft line, 90 degree vertical connector, the one next to HDMI port. The contact side is facing the HDMI interface when connected.
2. tear off the protective film on the lens before using
3. bare board, pay attention to ESD damage and avoid static electricity!
Software use:
1. RPI firmware and raspi config have been updated for camera. Please perform apt get update; apt get upgrade once;
2. select camera in raspi config, start camera drive in RPI firmware, and restart
3. use command-line programs raspivid and raspistil to operate the camera to capture video clips or images
4. the captured video clip needs to be played with Mplayer
Quantity: 1 piece
1. RPI firmware and raspi config have been updated for camera. Please perform apt get update; apt get upgrade once;
2. select camera in raspi config, start camera drive in RPI firmware, and restart
3. use command-line programs raspivid and raspistil to operate the camera to capture video clips or images
4. the captured video clip needs to be played with Mplayer
How to broadcast the camera data through Webcast:
The input data of camera is directly redirected to the network port to realize the output by NC command (NCAT - concatenate and redirect sockets)
Here is a detailed description
Parameters:
Lens: 1/45m
Aperture: 2.9
Focal length: 3.29
Field of view angle: 72.4 degrees
Hardware connection:
1. soft line, 90 degree vertical connector, the one next to HDMI port. The contact side is facing the HDMI interface when connected.
2. tear off the protective film on the lens before using
3. bare board, pay attention to ESD damage and avoid static electricity!
Software use:
1. RPI firmware and raspi config have been updated for camera. Please perform apt get update; apt get upgrade once;
2. select camera in raspi config, start camera drive in RPI firmware, and restart
3. use command-line programs raspivid and raspistil to operate the camera to capture video clips or images
4. the captured video clip needs to be played with Mplayer
Quantity: 1 piece
