BAT WING RC airplane kit! Under 7 oz total flying weight! 21" wingspan. Fits a wide range of RC airplane brushless motors, or common drone electronics. This is the perfect park and yard flyer! The airframe is 3D printed. It's much tougher and a little lighter than balsa. These will take a beating! The covering is a vinyl-type adhesive covering that comes pre-cut. It's like putting on a sticker - very simple and no heat required!

Check it out on 3D RC Hobby! 

Looking at the Bat Wing design, one would say it has to be difficult to fly. But really it flies like most trainers; it is very stable and tracks as if it were on rails, even without the assistance of AS3X or flight controllers. Excellent roll rate, solid performance and superior design make this plane extremely fun, durable and easy to fly! 

The Bat Wing kit comes with the complete airframe, pre-cut covering & decals, pushrods & servo horns, and instructions. The Bat Wing can be ready to fly in less than one hour. All you need is a small amount of glue (we recommend ABS cement) and your choice of electronics (not included).

Airplane Specifications:

Material: PLA+

Control Type: Throttle & Elevons 

Wingspan: 21"

Length: 12"

Flying Weight: Approx. 7 oz (varies slightly with motor and battery size)

Recommended electronics (NOT included):

Servos: 3.7 gram micro (x2)

Motor Size: 1806-2200 800+ kv

ESC: 12 amp with BEC

Propeller: 5-6 inch

Battery: 2s LiPo 7.4v 200-400 mAh with XT30 connector

Radio / Receiver: 3-channel receiver + radio w/ elevon mixing

The photos show the plane with motor and propeller. These are NOT included*