# Product Installation Notes
Please read the following carefully to ensure proper installation and use of the product.
When you receive the product, [test it first, then install it], no returns after installation!!
Normally, filling one tank of air takes no more than five minutes. If the first power-on exceeds five minutes, stop immediately and check for air leaks.
Testing Steps
1. Install the air pipe and connect the air horn (if you don’t have an air horn, just block the air pipe so no air comes out).
2. Power it according to the voltage you bought. After normal power-on, it should automatically stop after 2–3 minutes when full.
3. Take a photo of the air pressure gauge once it’s full, wait 10 minutes, and check the gauge for any leaks.
If there’s a leak, use Teflon tape to fix it. If no leaks, test the horn sound, and if everything is normal, you can install it.
Notes for Extending Wires
- If you need to extend the wires, make sure the wire gauge is larger than the original one that comes with the machine.
- Keep the wire as short as possible. Just enough to use. If it’s too long, there will be too much power loss, insufficient output, and the machine will run slower.
