Note: This is an aftermarket replacement part, not an OEM product. The brand names and models listed are for compatibility reference only.
Product Specifications
Part Number (OE#): 93490-H8220
Interchange Part Numbers: 93490H8220
Condition: 100% Brand New Replacement
Product Name: Spiral Cable Clock Spring (SRS Contact Assembly)
Package: 1x Clock Spring
Note: Fits 4-Door Sedan ONLY (Does NOT fit Hatchback).
Does NOT include Steering Angle Sensor (Must reuse your original sensor).
Fitment:
For 2018–2023 Kia Rio Sedan （4-Door Sedan ONLY, Excludes Rio 5 Hatchback)
⚠️ IMPORTANT FITMENT (PLEASE READ)
SEDAN ONLY: Fits 4-Door Sedan models with a trunk. It will NOT fit 5-Door Hatchbacks (Rio 5) .due to different internal electrical configurations for models with a rear wiper.
NON-HEATED ONLY: Fits models WITHOUT a heated steering wheel. If your car has a heating button, this part will NOT work.
NO ANGLE SENSOR: This is the Clock Spring only. You MUST transfer your original Steering Angle Sensor to this new unit.
FEATURES: Fully supports factory Cruise Control and Audio buttons.
🛑 Technical Buyer's Guide (Avoid Returns)
To ensure you are purchasing the correct part, please verify the following:
Check your original part number: This is a direct replacement for OE# 93490-H8220 ONLY.
Visual Check: Compare your original part's pins and plugs with our photos before ordering.
Important Install Tip: Do NOT remove the locking pin until the unit is fully secured and the steering wheel is ready to be mounted.
🚨 FITMENT & COMPATIBILITY NOTICE 🚨
(READ BEFORE PURCHASE)
The eBay compatibility chart (Fitment) is for reference only and may not be 100% Accurate for your specific trim. Subject to the ebay message we send you.
The ONLY way to guarantee fitment is to match the exact OE Part Number from your original unit with the interchange numbers listed above.
If you are unsure, please send us your VIN (Vehicle Identification Number)\ OE number \Photos of original accessories (front and back and slot plugs) via eBay Messages prior to purchase, and our team will verify fitment for you!
⚠️ CRITICAL INSTALLATION WARNING:
1. Point the front wheels STRAIGHT AHEAD before removing the old clockspring.
2. DO NOT remove the plastic locking pin/clip on the new clockspring until it is fully installed and the steering wheel is properly aligned.
3. Improper installation, turning the steering wheel before the installation is complete, or failing to center the wheels WILL SNAP the internal ribbon cable instantly.
*Note: Professional installation is highly recommended. Damage caused by improper installation or buyer error is not covered under warranty and will void the return policy.
💡 FAQ & Troubleshooting (After Receiving Your Package)
- 1. Airbag/Fault Light ON or OBD Errors?
This is completely NORMAL after replacing a clockspring. You must manually clear the fault codes using an OBD scanner to turn off the light. - 2. Pins/Connectors don't match?
Please contact us first! Your original clockspring likely has an integrated Angle Sensor. You simply need to transfer (transplant) your old angle sensor to our new clockspring. - 3. Think it doesn't fit? DO NOT OPEN A DISPUTE.
If you encounter any fitment issues, please do not open a return or case immediately. Send us a message! We will solve the problem for you in the fastest time possible. - 4. Need help with Angle Sensor Transfer?
If you do not know how to transfer the angle sensor, please contact us for guidance, or we highly recommend seeking a local certified mechanic for professional installation.
🔧 INSTALLATION & TRANSPLANT GUIDE
▶ General Clockspring Installation Steps
▶ Angle Sensor Transplant Tutorial
Step 1:
Step 2:
Step 3:
