Fix worn, clicking, or loose doors on your older Toyota—without replacing the entire assembly. This 3D-printed rebuild kit replaces only the failed internal plastic components, restoring factory-like performance at a fraction of the cost.
Save Over $300+ – Rebuild all four doors for less than the cost of a single OEM assembly
Restore Like-New Feel – Eliminates door “popping” and restores smooth, controlled opening
Keep OEM Metal Parts – Reuse your original door check arm and housing
Upgraded Design – Reverse-engineered for improved durability over factory plastic
Easy DIY Install – No welding required; uses factory mounting points
Direct Fit – Matches original latch dimensions for a precise fit
After real-world testing, ABS proved to be the best choice:
Heat-resistant and wear-resistant
Reduces wear on the metal door check arm
Better long-term performance than PETG or ASA (which are too rigid)
2000–2006 Toyota Tundra (1st Gen)
Important:
Some 2004 Tundra Double Cab & select Sequoia models use a different front door design
This kit fits rear doors on those vehicles but may not fit the front
Not compatible with newer roller-style door checks
8 × Replacement ABS Plastic Buckles
(Enough for all four doors)
Note: Door panel and full assembly shown for reference only.
Drill out factory spot welds to open housing
Replace worn plastic components
Reinstall rubber springs
Apply dry lubricant only (graphite or PTFE)
Reassemble using factory bolts
Do NOT use grease or petroleum-based lubricants