Mass Air Flow Sensor Bosch 0281002531 Fits VW Volkswagen Beetle Jetta Golf 04-06
Specification:
Condition: 100% Brand New OEM Mass Air Flow Sensor
Replacement: Directly Plug-in Replacement
Material: Plastic
Color: As picture showed
Warranty: 51 Year
Note: Our mass air flow sensor is the same with the pic showed in the page

Compatibility/Fitment:
1998-2006 VOLKSWAGEN BEETLE 
2008-2009 VOLKSWAGEN BORA 
2006-2009 VOLKSWAGEN EUROVAN 
1999-2006 VOLKSWAGEN GOLF 
1999-2006 VOLKSWAGEN JETTA 

 FAQ about the MASS AIR FLOW (MAF) SENSOR:
FAQ1: WHAT does a MAF Sensor doThe Mass Air Flow (MAF) sensor measures the amount of air flow entering the intake manifold using a heated grid or wire. The PCM uses this signal primarily for fuel control.
FAQ2: WHERE are these sensors located?
The Mass Air Flow sensor is located in the intake ducting after the air filter.

 Steps: 
How to replace the MASS AIR FLOW SENSOR(MAF):
1. Position MAF sensor in the vehicle. Make sure the airflow direction indicated on the sensor is toward the engine.

2. Install sensor to air duct seal(s), if so equipped, on the replacement MAF sensor.
3. Connect the MAF sensor to the throttle body air cleaner ducts. If the sensor mounts directly on the throttle body, install and tighten the mounting screws to 10 ft-lb. DO NOT OVERTIGHTEN!
4. Position clamps over the air duct/MAF sensor connections and tighten. Replace the clamps if necessary. (NOTE: For the MAF sensor to work properly, the sensor/air duct connections must be airtight.)
5. CAREFULLY plug the harness connector lead into the MAF sensor.

Package Included:
1X of brand new Mass Air Flow Sensor/Meter (MAF)

Contact us:
Any question or problem, please contact us.