Note1:
Pls Use the vehicle fitment we've provided within the body of the listing to confirm vehicle fitment.
Note2:
Vehicles require that tire pressure monitor sensors are installed and properly activated.
Must be programmed to vehicle with TPMS Programmer or the relearn process in owners manual.
Failure to install and activate sensor will cause tire pressure monitor light to remain on.
Sensor operates on a 315MHz frequency.
FOR USE ON ALLOY WHEELS ONLY---20 DEGREE PITCH.
Simplified Relearn : OBDII required
SPECIFICATION :
Manufacture Part Number ：42607-0C070
ALTERNATE PART NUMBERS:
42607-0C050
42607-0C030
42607-08010
Battery Life: ABOUT 5YEAR
Operating Frequency: 315MHz
Made in USA
PACKAGE CONTENT :
Pls Use the vehicle fitment we've provided within the body of the listing to confirm vehicle fitment.
Note2:
Vehicles require that tire pressure monitor sensors are installed and properly activated.
Must be programmed to vehicle with TPMS Programmer or the relearn process in owners manual.
Failure to install and activate sensor will cause tire pressure monitor light to remain on.
Sensor operates on a 315MHz frequency.
FOR USE ON ALLOY WHEELS ONLY---20 DEGREE PITCH.
Simplified Relearn : OBDII required
SPECIFICATION :
Manufacture Part Number ：42607-0C070
ALTERNATE PART NUMBERS:
42607-0C050
42607-0C030
42607-08010
Battery Life: ABOUT 5YEAR
Operating Frequency: 315MHz
Made in USA
PACKAGE CONTENT :
4PCS Tire Pressure Sensor
Fitment:
| For | Toyota | Sequoia | 2014-2015 | 42607-0C070 |
| For | Toyota | Sequoia | 2016-2017 | 42607-0C070/ 42607-08010 |
| For | Toyota | Sienna | 2014-2020 | 42607-0C070 |
| For | Toyota | Tundra | 2012-2017 | 42607-0C070 |
| For | Toyota | Sequoia | 2008-2013 | 42607-0C050 |
| For | Toyota | Sienna | 2007-2013 | 42607-0C050 |
| For | Toyota | Tundra | 2007-2011 | 42607-0C050 |
| For | Toyota | Sequoia | 2008-2013 | 42607-08010 |
| For | Toyota | Sienna | 2007-2013 | 42607-08010 |
Installation Process:
1. Loosen the tire: Remove the valve cap and core and deflate the tire.
2. Dismount the tire: Clamp the tire onto the tire changer, and adjust the valve at 1 o’clock relative to the tire separation head. Insert the tire tool and lift the tire bead onto the mounting head to discount the head.
3. Dismount the sensor: With a screwdriver remove the fastening screw and sensor from the Valve stem, then loosen the nut and remove the valve.
4. Mount sensor and valve: Slide the valve stem through the valve hole of the rim. Tighten the screw-nut with 4.0 Nm with the help of the positioning pin. Assemble the sensor body against the rim and tighten the screw.
5. Mount the tire: Place the tire on the rim, making sure that the valve faces the separation head at an angle of 180 degrees. Mount the tire over the rim.
