Clone PI-W Control Unit

Assembled and tested control unit for the Clone PI_W pulse metal detector, powered by an 18650 battery (not included). The unit is assembled in a D110 shock-resistant plastic case. Inside the case, the board has: a holder for an 18650 battery, a 12V step-up converter to ensure stable power supply to the board, and a built-in charging controller with a micro USB connector on the front panel for charging the battery.

- Firmware version 1.2m.

- Comes with a matching connector for the sensor.

- D110A housing.

- Power supply — 1 x 18650 battery (not included).

The board is powered by a single 18650 battery via a step-up converter. When installing the battery, pay close attention to the polarity (+/-)! There is a micro USB connector on the front panel for connecting a standard charger. The unit has a built-in charge controller! ClonePi-W is a modern universal pulse metal detector based on a microprocessor. The device is designed to search for metal objects in the ground, sand, walls, thick grass, etc. Using the device in combination with replaceable sensors of various sizes allows you to perform a wide range of tasks in treasure hunting, construction, searching for lost items, and other specific areas of human activity.

Main technical characteristics:

Maximum depth of object detection (in air):

With ring sensor (diameter 24 cm):

Coin with a diameter of 25 mm — up to 30 cm;

Helmet — up to 60 cm;

Maximum depth up to 150 cm;

With loop probe coil (1.2 x 1.2 m)

Helmet — up to 140 cm;

200 l steel barrel — up to 200 cm;

Maximum depth up to 300 cm.

Indication: visual LED;

Audio multi-tone;

Static search mode;

Continuous operation time with a fully charged battery up to 15 hours.

Operating conditions:

Air temperature — 10...+50 °C.

Atmospheric pressure 710...800 mm Hg.

Relative humidity up to 95% at a temperature of +25 °C.