This product reduces the sticking issue on the Turtle Beach Velocity One Yoke Controller.
We also sell the SmoothFlight Mod on Etsy and have over 80 x 5 Star Reviews, just search for "Velocity One" on Etsy.

**************************
Customer Reviews:

"This thing fixed all my issues. I had bought the 2 wheel design from someone else on here and printed it myself. This one is far superior."

"Super fast postage, I had the old version of this, which just supported the bottom, finding it would still stick sometimes, this one is awesome, easy to fit too. Well done."

**************************

If you found this page, you're likely familiar with the VelocityOne's sticky yoke issue, where the yoke shaft contacts the plastic on the base unit, resulting in the yoke not moving smoothly.

This product reduces the problem by positioning the shaft on bearings at both the top and bottom, preventing any contact between the shaft and the surrounding components during use.

This greatly reduces the shaft from "sticking" and is worthwhile improvement from the out of box experience.

This is a made to order product and consists of:

2 x 3d Printed Pieces (bearings included & pre-assembled)
2 x M5 Nuts
2 x M5 x 30mm Screws

No assembly instructions needed as it comes pre-assembled, however you can watch a video on the installation, just search for "SmoothFlight Mod" on YouTube.


**************************
It's an improved design from the 2 wheel version available on Etsy, some customers have used both and commented positively, see our reviews on our shop.

**************************

Please Note: This is a 3D-Printed product, designed with functionality as the priority. While the finish may have imperfections inherent to the 3D-printing process, these do not affect its performance or effectiveness.

Copyright Notice: This design is registered with the UKIPO. The reproduction, duplication, or distribution of this design without prior written permission from FixProCo is strictly prohibited.