Effective July 2023
Residential Delivery On Transmissions is an $100.00
PROMASTER 62TE TRANSMISSION
(CORE RETURN MANDATORY FOR WARRANTY)
We will ship to LTL Dock for Pick up OR Any Commercial Address
Transmission includes torque converter.
Transmission Quality Checks
• All transmissions are completely disassembled and cleaned.
• All cases are media blasted
• Internal parts are inspected for wear or damage and replaced as required.
• All bushings are inspected and replaced as required.
• 100% of friction components are replaced with upgraded heavy-duty parts.
• Drum assemblies are air checked and side play is checked to assure proper clearance.
• 100% of seals, O-ring’s and gaskets are replaced.
• 100% of solenoids are checked and replaced if they do not pass duty cycle tests.
• Internal wiring harness are checked and replaced as necessary.
• Valve bodies are disassembled, cleaned, and measured for wear.
• Valve body valves and valve bores are inspected, and valve bores are machined as required.
• Completed valve bodies are tested for proper operation prior to dyno testing.
• Transmissions are assembled, end plays are set, and fasteners are torqued to the required specification.
• 100% of transmissions are dynamometer tested to ensure proper pressures and shift quality throughout the operating range.
• All upshifts and downshifts are checked against preset parameters.
• Torque converter stall speed and lockup is verified on the dyno test.
• Transmission park locking mechanism is checked during dyno test.
3 YEAR UNLIMITED MILEAGE WARRANTY
62TE Transmission Installation Warnings
CHECKLIST
• Compare replacement transmission and torque convertor to original before installation.
• Scan original vehicle computer, record any codes for later review and resolve all codes.
• Transmission cooler and lines flushed or replaced.
• Inspect flex plate closely and completely for cracks or any damage.
• Inspect all engine and transmission mounts for wear and damage.
• Be sure both dowel pins are clean, installed properly, and are in good condition.
• Seat the torque converter completely in the transmission prior to installation in the vehicle.
• Verify that the engine block and bell housing surfaces are clean and free of paint, grease, oil and corrosion.
• Torque converter bolts stretch with use. MUST replace with new bolts.
• Test all sensors and switches that have been transferred from the original transmission for correct operation.
• Must use ATF+4 fluid in this application.
• Confirm that the transmission has a good ground connection; reattach all ground straps to the correct location free of paint, grease, oil and corrosion.
• Verify that the engine block and bell housing surfaces are clean and free of paint, grease, oil and corrosion.
QUICK LEARN PROCEDURE
The installing facility should verify they have the proper tools and that the scan tool they have can perform the necessary procedures. The vehicle may also be towed to a dealership to perform these functions. **DO NOT OPERATE without this being completed** Operating the vehicle in any manner without performing the procedures described above can cause immediate damage to the transmission.
To perform the Quick Learn Procedure, the following conditions must be met:
• The brakes must be applied
• The engine speed must be above 500 rpm
• The throttle angle (TPS) must be less than 3 degrees
• The shift lever position must stay until prompted to shift to overdrive
• The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the DRB III indicates the procedure is complete.
• The calculated oil temperature must be above 60°F and below 200°F
1. Plug the DRB III scan tool into the diagnostic connector. The connector is located under the instrument panel.
2. Go to the Transmission > Miscellaneous > Quick Learn Procedure screen.
3. Follow the instructions of the DRB III to perform the Quick Learn Procedure.
SHIPPING DETAILS
Transmissions are shipped LTL Freight to the nearest Estes Express or Old Dominion Freight Terminal for Pick Up.
We will also ship to any business (verifiable) for same flat rate. Residential Delivery is an additional $100.00. Please call us at
There are extra shipping charges to the following western states: Oregon, Montana, Wyoming, Colorado, Utah, Idaho, Nevada, California and Washington. Choose "economy shipping" for shipping at check-out if you live in one of these states.
(This does NOT apply if item has free shipping)
We custom build each and every one of our transmissions for our customer's application using our high quality components. Our transmissions are all extensively modified to be highly competitive and very durable. We strive to exceed your expectations with competitive, high quality remanufactured transmissions. Each transmission passes a series of rigorous tests before it ships to you.
Every Ebay transaction is important to us, whether a 99 ¢ part or a $1,000 transmission. If you are dissatisfied in any way, please call us and give us the opportunity to make it right. We also have experienced technicians available to answer any questions you may have.
Small Parts are shipped via UPS or USPS.
You MUST include phone number with payment.
Item will NOT be shipped until phone number is received. Shippers will not deliver without phone number.
***INTERNATIONAL ORDERS ARE SHIPPED TO CLOSEST AIRPORT**
You must clear customs, pay any duties or taxes due.
NO WARRANTY ON INTERNATIONAL SALES!
We will always try to assist as best as possible, but we can not import and export freight for warranty