Fitment:Fuel Filter for F250 F350 F450 F550 Super Duty 6.4L V8 Powerstroke 2008-2010 Diesel Engine.
Replaces part number:FD4617,8C3Z9N184A,8C3Z9N184C,PF7934,FK48002,CS10263,L4609F,1848522C93,33950.
Superior Filtration Media:Optimally screening out 98% of abrasives such as water,carbon,sand,dust and bits of metal before they get into your engine.
Easy to install:Just need to spend minutes to replace the filters with socket wrench and hands.
Package Includes:1 x FD4617 Fuel Filter.
Compatible with:
For 6.4L Powerstroke Turbo Diesel Fuel Filter for V8 engines
For F250 Super Duty 2008-2010
For F350 Super Duty 2008-2010
For F450 Super Duty 2008-2010
For F550 Super Duty 2008-2010
Location of the filters:
The primary fuel filter is located in the Horizontal Fuel Conditioning Module,mounted to the driver side frame rail.The Horizontal Fuel Conditioning Module also contains the water-fuel separator.The secondary filter is positioned on the top side of the engine,just right of the engine oil filter.Recommends replaces both fuel filters at 15,000 mile intervals under "normal" service conditions and 10,000 mile intervals under "severe" service conditions.
The primary fuel filter install:
1.Remove the drain plug uses a 6 mm Allen wrench for the water-fuel separator and drain the fuel into a container.Allow the Horizontal Fuel Conditioning Module to drain completely,then fish out the drain plug and dispose of the fuel.
2.Remove the primary fuel filter cap with a 36 mm socket.
3.Remove the fuel filter from the cap by simply pulling it out. There is a retaining clasp on the fuel filter that snaps into the fuel filter cap.Remove and replace the o-ring from the fuel filter cap.
4.Install the new fuel filter, minding the orientation of the locking clasp and the o-ring. The o-ring side of the fuel filter is not inserted into the cap. The fuel filter should lock into the cap.Lightly coat both o-rings (cap and bottom of filter) of the new fuel filter with clean motor oil before installing into the Horizontal Fuel Conditioning Module.Torque cap to 19 lb-ft (25 N-m).
5.Reinstall the fuel-water separator drain plug.
The secondary fuel filter install:
1.Remove the cap with either a 24 mm socket or 1/2 inch square drive.
2.Remove and discard the used fuel filter.
3.Drain the fuel filter housing of any fuel.Install the new fuel filter into the fuel filter housing.
4.Remove and replace the o-ring on the fuel filter cap. Lightly coat the o-ring with clean motor oil, then reinstall the cap. Torque to 10 lb-ft (14 N-m); do not overtighten the cap.