New Hall Effect design. The thing that makes the hall effect sticks much better than the normal sticks in controllers is that they use magnets to detect the movement rather than the standard wheel sensors that wear out quickly causing stick drift or random movements. These are much higher quality that the standard sticks, they are much longer lasting, you can manually calibrate them yourself so even if over time the magnet moves slightly you can simply just manually recalibrate it to adjust this movement. They click much more responsively than the originals as well so you don't have to press as hard to run on games etc..

Description:

- Hall effect joysticks (Choose the quantity you would like from the selection box)

- These use magnets to detect movement rather than the traditional wheel sensors that come with standard controllers. Magnets are much more accurate and much longer lasting the the standard wheel type sensors that wear out quickly.

- These are much higher quality providing an easier more responsive click (easier to run in games), have a strong spring back motion so they won't go soft or get stuck at the edges of the controller. 

- Soldering is required to install these. They will also require calibration to get them set up to your controller as all controllers are calibrated differently. I use these to repair PS4 controllers myself and the easiest way to calibrate them is to keep the main circuit board out of the controller, attach the usb port to the board and plug it into the computer. Open a controller tester that detects the sensitivty of the analog sticks. Then push the anolog stick to one side, whilst it is in place put a pin or tiny screwdriver in one of the holes in the sensor (see picture on listing) then push the stick towards the middle (you should feel a little resistance). Once you have done this a bit you should see the difference on screen. So you will need to do this for each direction so that the resistance is as low as possible (doesn't have to be exactly on the centre just below 10% resistance roughly i find works.) If you have any trouble with this i have a youtube video for a tutorial on how to calibrate them.

- These will only work with Genuine Sony and microsoft ontrollers 

- If using for PS4 Please not they will only work with the following model numbers JDM-030, JDM-040, JDM-050 and JDM-055. They will NOT work for the earlier model numbers of JDM-001, JDM-011 and JDM-020.