Part Number
97555, 471-7054, 10361920, 11197555, CO 4918ZI,CO 4918T, CO 4918, 5512349, CO 4918AC, 98555
Fitment
2006-2011 For honda Civic 1.8L
Package Including
1 x A/C Compressor with Clutch
Note:
Please make sure the installation site is clean. Or it will cause operating obstruction, making the compressor's temperature very high, and the belt on the clutch may melt.
But you need to add the refrigerant. Please add it to 70-80%. Try not to fill it up. There may be noise if the refrigerant is added too much.
Installation Steps:
Once the old compressor has been removed, begin by removing the receiver/drier or accumulator and the expansion valve or orifice tube from the vehicle.
Next, flush the condenser and evaporator using a non-oil-based A/C flush. The valve must be removed from the expansion valve system before the evaporator can be flushed.
Flush evaporators from inlet to outlet.
Install the new receiver drier or accumulator and a new expansion valve or orifice tube.
Next, install the new or remanufactured A/C Compressor.
Install and tighten the A/C Compressor mounting bolts.
Reconnect any electrical connectors to the A/C Compressor.
Re-install the refrigerant lines and A/C belt to the A/C Compressor.
Reconnect the negative battery cable.
Evacuate the A/C system with an A/C servicing machine for at least one hour.
Check the system for leaks.
If there are no leaks, install the refrigerant charge (Check the A/C system sticker under the hood of the vehicle for the proper amount and type of refrigerant for the system). Then, let the system set for 2 minutes. Doing so will allow the refrigerant to carry the oil and spread it more evenly throughout the system.
Start the vehicle’s engine and turn on the A/C system.