BRAND NEW 

AUSTRALIAN MADE

FRONT & REAR

BRAKE HOSE SET (4)

FITS

VW 1600cc BEETLE 1970-1975
1302S & 1303S
WITH MANUAL TRANSMISSION

**NOTE**

THIS SET IS SUITS MODELS WITH MALE FITTINGS ON EACH END FRONT HOSES

PICTURE FORMS PART OF THE DESCRIPTION

CHECK YOUR CAR BEFORE ORDERING IF YOU ARE NOT SURE

WITH ORIGINAL FACTORY BRAKES

ALSO CAN BE MADE IN STAINLESS STEEL BRAIDED LINE

CHECK MY LISTINGS OUR MESSAGE ME THROUGH EBAY


OVER 43 YEARS IN THE AUTOMOTIVE INDUSTRY


ALL OUR HOSES ARE MADE TO ORDER HERE IN AUSTRALIA BY US

OUR HOSES ARE MADE USING THE HIGHEST QUALITY FITTINGS AND HOSE

FROM THE U.S.A.

ALL HOSES COMPLY WITH AUSTRALIAN AND INTERNATIONAL STANDARDS

ADR42/04 FMVSS106

ALL OUR HOSES ARE TESTED AT OVER 3000 P.S.I.



Old-Fashioned 'rubber' brake hoses traditionally fitted to cars and motorbikes have a relatively short reliable life.

The estimated life of a typical 'rubber' brake hose is 6 years, then, they can become safety hazards. Imagine brake hoses as arteries in the human body. A person could live a normal life with hard and restricted arteries, but it's when they exert their heart to some stress that symptoms arise, the same applies to brake hoses.

Brake hoses could appear OK but it's when they are subjected to extreme pressures in an 'emergency stop' is when they need to be in good condition to handle this stress.

Most braking systems with boosted assisted brakes obtain pressures of approximately 1500psi.

OUR HOSES ARE TESTED AT OVER 3000 PSI.