|
Product Introduction : Instead of using expensive HDMI cables, This item 60m HDMI extender over a single UTP cables with IR control lets you use your existing Cat6A/ 6 cables/sockets while also performing the same functions like transferring Deep Color video and new lossless compressed audio. And if that weren't enough, you can use your existing remote to control your device through an IR blaster.
Features: HDMI Single cable transmission:It extends HDMI 1080P AV signal to at least 60M with 60M cat6 or higher level cables. UTP/STP cat6/6A/7 cable, follow standard IEEE-568B.
Package Content (no retail box):
HDMI to RJ45 sender TX*1pcs IR receiver extension cable*1pcs Note 1: Power Supply Adapter -----Optional.
Note 2 : Using Problem Pls note first before purchase:
1. 372A using network cable requirements:
must be a real CAT6 or CAT6A network cable. Many of the network cable on the
market can access to Internet, but can not be used in the extender, the transmission is not a network signal but HDMI signal,
so the higher requirements on the network cable.
2. Cable length is recommended 20 meters -60 meters, less than 20 meters of the signal is too strong, and someTV sets and displays
will not be displayed, so either long network cable or short network cable will not show. (Many users test with short network
cable is not displayed)
3. 372A is automatically identify the length of the network cable, connect the wire and if power is not displayed, you need to adjust the TX and RX end of the reset button, press once or twice until the display is normal (image flash or flash line can also press the reset button to try)
4. This product is not TCPIP protocol, it is not accessible for switches and other network products, only TX — cable—RX—display.
5. 372A output signal is recommended to access the brand TV or monitor directly, do not use together with any other converter.
6.Only supports the PCM audio output
7.Do not hot plug when it is working.
8.Please make sure the TX and RX connect correctly,pls press RX RESET button when no image output.
9.Please make sure the cables follows 568B and reset TX/RX to input HDMI Signal when RX"LINK" Led is flashing all the time.
10. One to one only, One Sender Matches to One Receiver ! The TX or RX cannot be used alone.
Only when your old TX or RX is broken,you need to buy it seperately.
|
|
Note:to different factory batches,sometimes real item may be a little different,but with same function and quality,pls note and understand,thanks~
Very important :