One ready-to-program with battery-installed Remote for your aftermarket Astrostart or Astroflex installed security system

This item is pre-owned – it will work like new once programmed to your vehicle

One (1)

Aftermarket remote keyless entry fob alarm

Transmitter control clicker keyfob controller replacement

PRE-OWNED for OEM FACTORY AFTERMARKET AFTER MARKET KEY 

REMOTE KEYLESS ENTRY FOB ALARM REPLACEMENT TRANSMITTER

 KEYFOB CLICKER CONTROLLER STARTER CAR START AUTOSTART CONTROL TRANSMITTER

FUNCTIONS AT 100% TESTED & GUARANTEED

Astrostart

 Compatible With These Systems: 
Astrostart RSS-4204A, RSS-2205A, Astrostart Series/Model 500, 1100, 2100, 4100
FCC ID:
J5F-TX2000
IC ID: 
CAN1851021168
Model Number: 
310-052-300

Battery Type: INSTALLED  CR2016 X 3

REMOTE MADE FOR: ASTROSTART / ASTROFLEX ®
BUTTON: 5

LED or LIGHT: GREEN
Is this a 1 Way Keyfob?: Yes
FCC ID: J5F-TX2000 J5FTX2000
P/N: 310-052-300-10  31005230010  IC ID: 
CAN1851021168
Model Number: 
310-052-300

 

Compatible with the following systems:

Works on these aftermarket systems (Module Part Number: 392-1273-317):
Astrostart RSS-4204A, Astrostart RSS-2205A, Astrostart Series/Model 500, Astrostart Series/Model 1100, Astrostart Series/Model 2100, Astrostart Series/Model 4100, AstroStart 1105, AstroStart 1105U, AstroFlex 1105, AstroStart 1100, AstroFlex 1100, AstroFlex 2006, AstroStart 2006(A&B), AstroStart 2106XR, AstroStart 2106U, AstroStart 3106(A), AstroStart 3106(U), AstroFlex 3106M, AstroStart 4204-A.

 

 Programming procedure:
1. Open hood.
2. Place key in ignition and turn to RUN position.
3. Apply the brake once.
4. You now have 10 seconds to turn the key from RUN to STOP position 3
times.
5. If this sequence is correctly carried out, the control module flashes
parking lights.
6. Press any button on the new remote control (except the panic button).
When access code of new remote is memorized, the control module will
respond with 1 flash of the parking lights.
7. Repeat the above procedures for each remote control that has to be
programmed, up to four remotes.
8. Apply the brake.
9. New remotes are ready and now added to the system.                                                                                                                                                                                                                                                                                                                                      

remote requires programming to work with your compatible system. see below

Please note there are several compatible remotes that look similar but not exactly like the photo pictured. We will do our best to ship you the remote pictured; however, the remote you receive may look different than the remote pictured. No worries, the board will program to your system the same.

Condition Explanation: Pre-Owned

Pre-Owned:  An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. Scroll through listing for full details and description of any imperfections.