Warm Tips:
*We suggest you make a test prior to making sure it is not cutting through the transfer/carrier sheet, just peel a little on edge. This will prevent wasting any full sheet!
*If our vinyl can not iron on T-shirt, please check 3 key points: Pressure/Temperature/Time. Increase them and try it again.
*Do not use nylon, velvet, acrylic fabrics, leather, which will melt and ruin the material.
Cut Setting:
For Cricut:
Mode: Iron on +
Blade: Standard
For Silhouette Cameo：
Material: Heat Transfer, Smooth
Blade: 10
Force: 5
Speed: 5
Passes: 2
Application Instructions (HOME IRON):
1. Set iron dial between Wool and Cotton
2. Cover design with a cover sheet (Teflon Sheet)
3. Place on a flat, hard surface (ironing board not recommended)
4. Press iron with medium/firm pressure (do not slide iron)
5. Press each section of the design for 10-15 seconds, apply design at 305 °F
6. If the area of design lift after application, apply cover sheet and repress for 10-15 seconds
7. Peel carrier cold
8. Cover completed design and press for 5-10 seconds
Application Instructions (HEAT Press)
1. Set heat press to 300°F-320°F
2. Pre-heat the garment with medium pressure for 2-3 seconds
3. Apply for transfer as instructed above on garment and cover with a Teflon Sheet
4. Apply medium pressure to the garment for 10-15 seconds
5. Allow the transfer to cool for 45 seconds before peeling off the clear carrier sheet
Washing Instructions:
1.Turn the garment inside out.
2.Machine wash COLD with mild detergent.
3.NO bleach.
4.Dry at a normal dryer setting on household machines.
5.Do not dry clean.
6.Instructions apply to the material only, please follow garment washing instructions as well.
Note:
1. Please allow 1-3cm error due to manual measurement.
2. The colors may have different as the difference display, please understand.