For Royal Enfield Bullet 350/500 Clutch Centre Extractor Tool

 

*It is a special service tool used to remove the clutch centre (clutch hub) from the gearbox shaft.

*The threaded center bolt applies force against the shaft, pulling the clutch center off safely.

*Without it, removing the clutch hub can damage threads or bearings.

 

How  specific tool works

*The round plate with 3 bolts mounts onto the clutch center.

*The central pointed screw presses against the main shaft.

*When you tighten the top hex bolt:

-It pushes inward

-That force pulls the clutch center outward

🛠️ Compatibility

Your tool design is typically used on:

Bullet 350 (Electra / Standard)

Bullet 500

Older cast iron / AVL / 4-speed & 5-speed setups.

Key tip:

Before using:

Apply a little grease on the center screw tip

Tighten gradually (don’t shock it with hammering)

If stuck, slight heat or penetrating oil help.