Now available in DILLON BLUE!

Designed to press-fit over the Dillon shellplate bolt with the Entirely Crimson or UniqueTek roller bearing stack underneath, for consistent and reliable ejection of completed cartridges. (It does also work with just the shellplate bolt, as shown in the initial photos.)

Ejector arm slips over the existing Dillon ejector wire (to prevent rotation) and provides a gentle push against completed rounds from shellplate upward, eliminating sideways case binding which usually occurs when a smaller case is pushed from further up along the sidewall.

“Foot-like” protrusions prevent the ejector from being pushed down too far against the shellplate and binding it up, and notches on the side make for easy insertion of a screwdriver for removal.

Printed in PETG material for temperature and chemical resistance, as well as toughness.

Pack Quantity of 1

Tested with smaller-diameter cartridges such as 380, 9mm, and 223. Larger cartridges such as 45 may not have enough clearance between ejector arm and the shellplate carrier to properly eject.

YouTube video on the design can be found by searching the video total shown in the last item photo above.