LED HEADLIGHT & FOG LIGHT KIT — 9005 HIGH / H11 LOW / FOG (6500K COOL WHITE • PLUG-AND-PLAY)

— ABOUT THIS ITEM —
• Up to 300% brighter vs. stock halogen with a focused beam that reveals road signs clearly without dazzling oncoming drivers.
• Long-throw visibility (~450 ft, vehicle-dependent) helps you spot hazards sooner on rural roads and dark highways.
• Fast install (~10 minutes per side) — ultra-thin 0.5" heat sink fits most housings, even with dust covers.
• 6500K eye-comfort color — crisper contrast than 3500K halogen without the harsh bluish tint of over-cool lamps.
• All-weather performance — IP67 sealing and a wide operating range keep output stable in rain, snow, heat, and cold.
• Thermally stable design — heat-pipe + aluminum radiator + high-speed fan help maintain brightness over time.

— KEY SPECS —
• Models: 9005 (HB3) High Beam / H11 Low Beam / Fog (pair)
• Voltage: DC 12–30V
• Power: 80W (pair)
• Luminous Flux: up to 20,000 lm (pair)
• Color Temperature: 6500K Cool White
• LED Chips: AUIMSOCO customized CSP
• Material: Aviation-grade aluminum
• Waterproof: IP67
• Operating Temperature: −45℃ ~ +150℃
• Placement on Vehicle: Front — Left/Right
• Cooling Architecture: Heat-pipe technology + aluminum radiator + high-speed fan
Note: Packaging may vary.

— WHAT’S IN THE BOX —
• 2 × LED Headlight Bulbs — High Beam (9005/HB3)
• 2 × LED Headlight Bulbs — Low Beam (H11)
• 2 × LED Fog Light Bulbs (pair)

— PERFORMANCE DESIGN —
• Focused optics for a clean cutoff and reduced stray light, improving sign readability and minimizing glare.
• Active cooling with a low-noise fan to sustain lumen output during long night drives.
• Robust build with aluminum chassis to move heat away from the LEDs for longer service life.

— INSTALL CAUTION —

  1. Allow the vehicle to cool down before installation.

  2. Park securely; switch off ignition and remove the key.

  3. Avoid burns when lights have been recently switched on/off.

  4. Do not touch LED emitters with bare fingers; handle bulbs by the base.

  5. Examine connectors, terminals, and wiring; poor contact may cause flicker/no-light.

  6. Ensure the bulb is fully seated/locked and does not contact the internal shield or lens.

  7. After installation, re-aim headlights to achieve a sharp cutoff and proper road coverage.

Datacaciques