Features:
- Can operate on any voltage from 7.5V to 15V, conveniently powered with a 9V or 12V power supply or battery
- High efficiency: 90%
- Provides 10W (left channel) + 10W (right channel) output power into an 8Ω speaker load and 12V power supply
- CMOS class D amplifier design for high efficiency and low cost
- Screw terminals for easy speaker connection - no soldering needed
- Noise canceling circuit built into the amplifier board
- Power on / off without popping noise
- Includes a mute switch connector (wire external SPST switch to this connector to provide remote mute) and an onboard volume control potentiometer
- The module has short-circuit current protection, under-voltage lockout and over-temperature protection (shuts down at an internal temperature of 140C +/- 15C)
Specifications:
- Audio input connector: 3.5mm stereo headphone jack
- Remote mute switch connector: JST-style pins with 2.54mm (0.1") pin pitch
- Output power: 10W + 10 W (8Ω)
- Frequency response: 20Hz to 50KHz
- Amplifier class: D
- Operating voltage: 7.5 - 15V DC
- Recommended DC supply voltage: 12V at ~2A, the connector is a DC power jack with a 2.1mm center pin and a 5.5mm outer shield.
The center PIN is + - Quiescent Current: 20mA
- Efficiency: 90%
- Speaker Load: 4-8 Ohms, 8 Ohms recommended, screw terminal connectors
- Size: 40 x 40 x 22 mm (L x W x H); 55 x 40x 22 including volume control knob
- Volume control potentiometer shaft diameter: 6mm
- Net weight: 24g
Notes:
This module has floating outputs, therefore the left and right channel "negative" connections should not be connected together. The
module is designed to drive speakers, it will not work with headphones, which usually share a common ground between the two channels.
module is designed to drive speakers, it will not work with headphones, which usually share a common ground between the two channels.
The volume control knob may be a different style or color than the one shown in the photos.
Package Contents:
2 x PAM8610 10W+10W Class D Stereo Audio Power Amplifier Module
On Jun 12, 2025 at 23:06:37 PDT, seller added the following information: