Universal for all car airbags and belt tensioners also for all cars that are not on the COMPATIBILITY LIST!!!!
The igniters of Allen airbags and seat belt tensioners are the same and come from the same manufacturer!

THE ARTICLE WILL BE DELIVERED IN RED OR BLACK DEPENDING ON STOCK!!!!
The product is a testing tool (test resistor) for airbags and belt tensioners for fault diagnosis!
For car workshops: you You can use the bridge to rule out fault diagnosis for Airbag and belt tensioner defects!!!!

We also repair triggered and defective Airbag control units of all models
Installation is very simple: pull the cable from your defective component and connect the bridge behind the plug using the ones provided
Power taps. There is no polarity to consider. Or plug the bridge using small MQS pin contacts ( MQS pin contacts not included
included) simply plug it into the plug. 
Or simply remove the insulation at one point on the Airbag or belt tensioner cable and solder the bridge between them.
Then delete the error if this works then you know that your Airbag control unit is OK and it is due to the Airbag / belt tensioner
The article is compatible with Allen common reading devices / diagnostic devices!

If you have any questions, please call us or write to us via WhatsApp/SMS/Email 

Safety notice:
The testing tool may only be used for testing purposes or Troubleshooting can be used! Work on the entire Airbag system may only be carried out by trained personnel! 
We assume no liability for improper handling or damage caused by our product. 


Note about the product!!
The items offered are not an OEM product from the vehicle manufacturer!! 
All information and brand names used are for illustration and compatibility of the product only! 
Universal for all car airbags and belt tensioners also for all cars that are not on the COMPATIBILITY LIST!!!! For car workshops: you You can use the bridge to rule out fault diagnosis for Airbag and belt tensioner defects!!!! Installation is very simple: pull the cable from your defective component and connect the bridge behind the plug using the ones provided Power taps. There is no polarity to consider. Or plug the bridge using small MQS pin contacts ( MQS pin contacts not included Or simply remove the insulation at one point on the Airbag or belt tensioner cable and solder the bridge between them. Then delete the error if this works then you know that your Airbag control unit is OK and it is due to the Airbag / belt tensioner The testing tool may only be used for testing purposes or Tr