Positive and negative knife sharpening machine imported pedicure sewing scissors hair cutting electric push pet shaving emery carving electric fine grinding multi-function
Product use.
Suitable for garment sewing industry. Shoes. Knitting. Leather bag... Hair cutting tools. Leather processing. Carpentry carving, pedicure hall. And home kitchen knife grinding. Etc.
Functional characteristics
The machine adopts imported high-precision carborundum grinding sand disc. When grinding various scissors and other tools, it can maintain the characteristics of high temperature in a short time. Effectively sharpen the sharp edges of scissors or other knives. Under normal circumstances, grinding does not require water cooling, but the blade is very sharp. Sharpening scissors can be done in less than a minute. Pedicure knife included. This product. Efficient.. Low cost. Portable. Easy to use. Low noise. Beautiful. Advantages
Operation instruction
Before starting to sharpen (cut) the knife, put the scissors to be sharpened on the knife holder with the machine stopped to adjust the Angle of the scissors and the grinder. (Generally in the 40-50 Angle is appropriate) and then remove the scissors. Turn on the grinder switch. Put the waist of the scissors back on the knife holder and use the middle and ring fingers of your left hand to gently push the scissors against the mill. At the same time, use the right hand to pull the scissors evenly to the right... The time of each operation should not exceed 4 seconds. Slow time will have a bad high-temperature effect on the scissors and may damage the cutting edge. If it's not sharp enough or the Angle isn't accurate. We can fine-tune the Angle. Grind it again... There is no annealing effect on the mill and scissors. Then use a thick cloth to wipe away the iron powder attached to the blade before you can try. Sharpening pedicures and hair clippers. Electric clippers that require the machine to stand up are very easy to use.
Safety and attention
Each time you load and unload the millstone, pay attention to the plastic tray to keep clean. If it is found that the four magnets on the plastic tray have iron powder sucked up. You can tape the iron down with tape. Then the millstone with a fingernail on the surface of the millstone to appear a white scratch is the front. You can't draw scratches on the back... And the back of the mill should be wiped clean with a clean cloth. When the millstone is held in place by four magnets, the sound of "contradict" indicates that the millstone and the support disk are aligned. No tools are used to load or unload the mill. You can just pick it off with your finger... The operator must pay attention to safety when using the machine.
Power: 180W. 50-60HZ
Disk size: 150mm
Disk speed: 400-4000 RPM
Tool holder working Angle: 45° -85 °.
Volume: length 240*161*182.mm
Net weight: 3.2kg