How to programme

1. Activate programming mode on the garage door operator
First, you need to switch the radio receiver of the garage door operator to programming mode.

To do this, open the housing and press the programming button (Radio button) on the control unit of the garage door operator.

Depending on the model, the control unit is located in the motor carriage or in the control unit housing. In programming mode, a red LED lights up.

2. Select radio channel on the garage door operator
Press the Radio button repeatedly to select the required radio channel on the garage door operator.

If no transmission command is received within approx. 30 seconds of pressing the Radio button, the radio receiver switches to normal mode.

Explanation of the radio channels
CH1: Pulse mode (OPEN/STOP/CLOSE)
CH2: Partial opening or lighting function
CH3: Defined OPEN
CH4: Defined CLOSE

3. Programme the button on the handheld transmitter
Press the desired button on the handheld transmitter until the previously selected LED for the radio channel blinks and goes out.

The handheld transmitter has successfully transferred the radio code to the radio receiver and is now programmed. Repeat the steps above to program other handheld transmitters to this radio receiver.

Handheld transmitters with Somloq2 can be programmed on either a Somloq Rollingcode receiver or a SOMloq2 receiver.

However, mixed operation of the Somloq and SOMloq2 radio systems on one button is not permitted.

Videos, programming handheld transmitter to garage door operator
Programming a handheld transmitter to a SOMMER base+ or SOMMER pro+ garage door operator
Our video shows how to programme a SOMMER handheld transmitter, for example a Pearl, Pearl Vibe, Pearl Status, Pearl Twin, Slider+, Slider Vibe, to a SOMMER garage door operator with SOMloq2.