Qty 1
UNIDEN BCD396T Digital Police Handheld Scanner.
Tested in fully working condition.
Good overall condition with normal light signs of wear, not abused.
*Partial hairline crack in the rubber on antenna (cosmetic only does not affect reception performance).
*The rubber side port cover is a bit stretched but stays in place and does its job covering the side ports (also cosmetic only).
Cleared out to factory original settings and ready for programming.
Includes scanner, AC power adapter and antenna as pictured.
No batteries, no belt clip or any other accessories came with these. Takes 3 AA batteries alkaline or rechargeable.
Buyer responsible to have programmed. I am not setup for anything programming related.
---------------------------------------------------------------------------------------------------------------------------------------
Uniden BCD996T - Additional info for reference only
Uniden's Base/Mobile Digital Trunktracker scanner with Dynamic Memory Architecture and GPS Support. This is a TrunkTracker IV scanner with Motorola Control Channel Only trunking and I-Call monitoring
Specifications
Physical
Antenna Connector: BNC
Compatible with BC-RH96 Remote Head
DIN-E and ISO Vehicle Mountable sleeve included
GPS Support for Location Based Scanning, location alerts, and crows-flight navigation
LCD and Keypad Backlight
Memory Back Up
Multi-color display backlight
Physical Dimensions: Width 7.33 Height 2.21 Depth 5.94
PC Programming and Control
Record Out - you can connect an output jack to a VOX controlled recorder or PC sound input to record the received audio.
Reversible Display - Lets you reverse the display to mount unit upside down (and hear the speaker from the top)
Signal Strength display
Single-Handed Function Operation - Tap Function to access F+ key presses. 5 seconds after your last key press, the scanner reverts to non F+ entry (or press Function again to revert sooner).
Six-Level Backlighting -Lets you set the display/keypad backlight to any of three brightness levels (or off) and two colors (red or green). Also lets you connect to your vehicle’s dimmer circuit to dim the scanner’s display with the vehicle’s dimmer control
Soft Search Keys -Lets you program the keypad’s secondary functions to turn on/off specified search ranges.
Strong signal attenuation
Trunking Activity Indicators
Keys
Group Quick Key range: 0-9
System Quick Key range: 0-99
6 Quick Access Search keys
Technical
Channels: 6000 maximum
Custom Search — lets you program up to 10 search ranges
Groups per system: 20 maximum
Preprogrammed Service Search Bands: 13
6 Quick-Access Search Keys
Scan Rate: 100 channels per second (conventional mode)
13 Service Searches - Public Safety, News, HAM Radio, Marine, Railroad, Air, CB Radio, FRS/GMRS, Racing, TV Broadcast, FM Broadcast, Military Air, and Special (Itinerant)
Sites: 1000 maximum, 256 maximum per system
Supported step sizes: 5, 6.25, 7.5, 8.33, 10, 12.5,15, 20, 25, 50 or 100 kHz
Systems: 500 maximum
Talkgroups per trunked system: 250 maximum
500 (250 Temporary + 250 Permanent) Search Lockouts
16 character text tagging for each system, site, group, channel, talkgroup, search range, location, Tone-out, and SAME group
Frequency Coverage
25 - 512 MHz
764 - 776 MHz
794 - 956 MHz
1240 - 1300 MHz
Power
Voltage: 13.8 Volts d.c.
Current: less than 750mA (max. rating of included wall wart)
Power plug: 5.5mm outer diameter, 2.1mm inner diameter
Features
Ability to flag a channel as Digital, Analog, or All
Adaptive Digital Threshold - Automatically sets the digital decode threshold for APCO 25 systems
Adjustable Hold (scan duration 0-255 sec) per system, custom or service search
Adjustable (0-5 sec) scan delay
Analog and Digital AGC
APCO25 Digital Audio decoding
Broadcast Screen while searching (TV and radio station frequencies, pagers, etc) with 10 custom bands
Close Call, with Close Call Do Not Disturb, Close Call Priority (or Primary), and Close Call Temporary Store.
Control Channel Only
Data Skip
DCS/CTCSS Rapid Decode
Duplicate Channel Alert
EDACS ESK support (requires firmware 3.0 or newer)
Fire Tone Out alert
Frequency/ID AutoStore - automatically store frequencies from a service or limit search into a conventional system or store talk group IDs into a trunked system
Independent Alert Tone Volume – lets you set the volume level of the following tones: Key Beep, Emergency Alert, Channel Alert, and Close Call Alert.
Location Based Scanning
Multi-Site support
Quick Recall – quickly navigates to a specific Channel by choosing the System, Group, and Channel.
Quick Search
Priority Scan
P25 audio decode level adjustment
Repeater Reverse
Search with Scan for Service and Custom Searches with assigned Quick Keys
Startup Configuration
Temporary System, Site, Group, Channel, and Location Lockout
Uniden Digital AGC Tweak Procedures
Upgradeable firmware
Can be updated to support Rebanding? YES
Weather Operations
Wired Cloning (Will only Clone to another BCD996T)
System Compatibility
System Types:
Motorola Type I
Motorola Type II
Motorola Type IIi Hybrid
Motorola Type II Smartnet
Motorola Type II SmartZone
Motorola Type II SmartZone OmniLink
Motorola Type II VOC
EDACS Standard (Wide)
EDACS Standard Networked
EDACS Narrowband
EDACS Narrowband Networked
EDACS SCAT - (version 3.0 firmware or later required)
EDACS ESK (not ProVoice)
LTR Standard
Project 25 Standard Phase 1