FCC ID: J5523518T1

 ( Alternate Spelling: 15523518T1, J55235I8TI , J55235l8Tl )

 Circuit board #: TX3B

 Frequency: 304 - 305 MHz

PT2262 Circuit Board TX3B Tested- working 100% - red led light 3 button - ready too program battery installed

 LED color: Red

 3 buttons

 Battery: GPA23 23GPA

Programming Instructions:

 Note:  You can program up to 4 remotes to the system at one time.  All existing remotes must be present and programmed at the same time.

 1.     Locate valet switch.

2.     Insert key into ignition and turn to “on” position- (do not start the vehicle)- and then back “off”.

3.     Repeat again- “ON”, “OFF”, “ON”- ending in the “ON” position. –The vehicle lights should flash at this point, indicating the vehicle has successfully entered programming mode.

4.     Hold down Valet switch for 5 seconds. – Vehicle lights will flash again.

5.     Within 15 seconds, hold down “lock” button on first remote- vehicle will confirm with a chirp or lights flashing when remote has been accepted.

6.     Repeat step 5 with any remaining remotes.

7.     To exit programming turn the key to “off” position.

J5523518T1 Programming Instructions: METHOD #1: You will need two things

1.The remote control

2.Valet Switch (aka: programming switch) (you will see a single Push button switch typically red or blue button and in the kick panel area under front drivers dash)

 To program you have about 15 seconds¦

 Can program up to 4 transmitters (program sequentially at the same time)

1.Get in vehicle

2.Key in Ignition

3.TURN ignition ON OFF ON OFF ON (leave on)

4.Lights in vehicle will flash leave key on

5.Grab valet switch

6.Push (hold down) button for 5 seconds

7.You will either hear a chirp or see a light flash let go

8.Grab transmitter (first to program) & hold down lock button until you either hear a chirp or see a light flash – let go

9.Grab 2nd remote & hold down lock button until you either hear a chirp or see a light flash let go

10.Grab 3rd remote & hold down lock button until you either hear a chirp or see a light flash let go

11.Grab 4th remote & hold down lock button until you either hear a chirp or see a light flash let go

12.Typically, about a 15 second window to do all of this in

13.           To exit program, turn key off

METHOD #2: Programming Instructions:  This system uses Code Learning to learn up to 3 different transmitter codes.

 TO PROGRAM TRANSMITTERS TO ALARM:

1) Turn ignition switch ON then OFF 3 times quickly (on/off, on/off, on/off) until siren chirps once.

2) Leave ignition ON.

3) Push & Hold the Valet switch. The siren chirps 3 times. The system is now in programming mode.

 4) Press BUTTON #1 on the transmitter- siren chirps once to confirm programming. Press BUTTON #1 on another transmitter within 5 seconds to program a second remote control.

 NOTE #1 If only one transmitter is being programmed, continue holding BUTTON #1 until Siren chirps a second time. This means the system has exited program mode. Hold the transmitter button until the siren chirps the 2nd time to prevent unauthorized code and noise from entering system.

 NOTE #2 Program Mode is exited automatically after 5 seconds of last code transmission or once 3 new codes have been programmed. System will disarm after programming. Disarm using any valid transmitter.

 5) Turn Ignition to OFF.  NOTE: When programming ALL remotes must be relearned!