Genuine GM Cadillac
ABO 0702T

New Battery Installed

why buy a nasty, dirty, faded remote with
a dead battery and gunked up circuit board buttons?!
this remote is in excellent condition, tested
and works great!  actual remote in pic.

send me your vin and I'll try to make
sure this is the correct remote for your car.

remote has to be synced to your car
programming help may be found at:
programyourremote.com or programming
by the professionals may be required.

most of you don't read this far but here is an 
example for programming:

1996 Fleetwood:

  1. Insert Key Into Ignition

    INSERT key into the Ignition and TURN to the ON/RUN position (just shy of cranking engine).

  2. Locate Programming Connector

    LOCATE the Programming Connector in the Driver’s side of the trunk. You may have to remove trim in order to access. 

  3. The Programming Connector will have two wires and a plug on the end of it with 2 ports.

  4. Jump Programming Connector – Enter Programming Mode

    Use a paperclip or similar conductive ground wire to JUMP the Programming Connector by connecting the two ports. Be sure you are making contact with the metal inside of each connector port. The vehicle should now cycle door locks LOCK / UNLOCK to indicate successful entry into Programming Mode.

  5. Program Remote

    PRESS the UNLOCK button on the first remote to be programmed 2 times in 1 second intervals. System should now cycle door locks LOCK / UNLOCK to indicate successful programming of the remote.

  6. Program Additional Remotes

    REPEAT Step 4 for any additional remotes to be programmed, including working ones.

  7. Exit Programming Mode

    REMOVE the jumper wire, TURN the Ignition to the OFF position and REMOVE the key from the Ignition to EXIT Programming Mode.

  8. Test Remotes

    TEST all remotes. Programming is complete.

Programming Notes:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes. You must program all existing and new remotes that you wish to use on the vehicle at this time.
  • You may clear your keyless entry system memory by entering programming mode as shown in the steps above.


Part Fitment

MakeModelYear
  • Engine
Important vehicle option details

Cadillac

Deville

1994-1995

  • 8 Cyl 4.6L, 8 Cyl 4.9L

4 DOOR

Cadillac

Eldorado

1991-1995

  • 8 Cyl 4.6L, 8 Cyl 4.9L

COMMERCIAL CHASSIS, ELDORADO

Cadillac

Fleetwood

1993-1996

  • 8 Cyl 5.7L

BROUGHAM, BROUGHAM 4 DOOR

Cadillac

Seville

1991-1995

  • 8 Cyl 4.6L, 8 Cyl 4.9L

4 DOOR, SEVILLE