Practical bright chrome finish not cheapo black coating.

NEW Large Sized 1/2" to 4-1/2" BEARING SPLITTER SEPARATOR PULLER REMOVER. 

We have found a large splitter that holds up to repeated shop use.  Will not "explode" and fragment or chip like cast.  This splitter is not to be compared to those featureless black oxide or coated or chromed splitters with undersized threaded pulling holes.

I can't know for sure, but probably just as good as the more expensive splitters out there.

Made for press work and pulling, this puller features 'knife-like" edges which are easily placed behind bearing, pulley, hub etc., to secure a gripping surface, even when clearances are extremely limited.

Standard two arm puller jaws grip attachment's outer edge; when used with a Push-Puller, threaded for 1/2"

Each jaw is threaded for pulling bolts (Use Grade 8 not inclused).  Some splitters actually come without this feature ...very limiting.

Weighs 5 lb. 12 oz oz.

Made for 6,12, 20, ton press work and 30, 40 and 50 ton press work when backed up with our press plates or straight bars.

 Features  and Benefits:

·  Max. Spread 4-1/2"

·  Min. Spread 1/2"

·  Distance between adjusting screws 4-3/8".

This versatile accessory provides a stable base for bearing, pulley, and hub work.

The quality and price of bearing splitters on eBay vary a lot.  Some of the imports out there are pretty crude. We have had no problem with these splitters and offer them at a fair price.

We know ours are hardened to Rockwell  42C to 45C and we have never had a return!

Second picture shows this item on our popular WIDE 4"x8" Press Bars (not included) available by clicking on our "other items".

This setup is shown on our 20 ton hydraulic press.  We use the tools we sell in our shop to insure their performance in your shop.

 New!