500 gram sealed jar of Brazetec h paste silver-brazing flux
Free postage
The following is taken from the Brazetec technical data information.
A paste type silver solder/brazing flux suitable for silver brazing most common base metals including stainless steels but not aluminium or its alloys.
Very effective and economical in use, ready-mixed paste form means that the health concern of powder inhalation is eliminated.
Being water-soluble means that all traces of potentially corrosive flux residues are easily removed.
Standard DIN EN 1045 FH10.
Based on boron compounds, fluoride
Flux for brazing steel, copper and copper alloys, nickel
and nickel alloys as well as -under special conditions on
stainless steel.
BrazeTec h paste is suitable for all flame and induction brazing procedures
BrazeTec h Paste meets the requirements of the working sheet "GW2" and "GW 7"of DVGW (German association for Gas and Water)
It is approved and registered by DVGW (DV-0101AU2227) and has been awarded by the Gütegemeinschaft Kupferrohr e.V. (Quality Association for Copper Tubes).
Typical application are found e.g. in the electrical industry, in the construction of vehicles and copper tube installation.
Standard DIN EN 1045 FH10 ,Based on boron compounds, fluorides
Working range approximately 550-970 deg Density approx. 1.6 g/cm³ (20 °C) Viscosity 150 - 250 dPa s (Haake Viscotester 02, Sp.2, 20 ±2 °C) Flux residues corrosive, water-soluble
All eBay recommendations apply – contact within three days, pay within ten etc. Listed carriage costs apply to UK bidders only and items may be combined to reduce cost. Please pay by PayPal, cash may be accepted on collection. ll descriptions are the result of research using the manufacturer's published data and given in good faith. In the unlikely event of an item arriving damaged or not as described, contact within five days and full refund will be given including any outward carriage charge. Items will be sent by the most cost-effective means depending upon circumstances, any other form of carriage requested is entirely at the buyer’s risk. Please confirm delivery by posting positive feedback which will be quickly reciprocated. All items, unless otherwise advised, are usually sent the same day and always within 24 hours of payment, please bear this in mind before leaving feedback as I have no influence over delays caused by Royal Mail or foreign customs Brazing and welding are established safe industrial processes which require degrees of skill, proper equipment and an understanding of basic health and safety procedures, please assure yourself that you are acquainted with this knowledge which is obtainable from the manufacturer's website and always comply with safety procedures laid down at the workplace. |
Thanks for your interest. |
This item is for UK buyers only.