Glass, replacement for gauges such as Stewart Warner, VDO, etc.
Slightly curved (concave on one side, convex when you flip it over)
90.7mm or 3.57" diameter are the actual measurements

1.8-2 mm thick

NOTE:  IF THIS GLASS IS A LITTLE TOO BIG FOR YOUR OPENING, THE EDGES OF THE GLASS CAN ACTUALLY BE SANDED DOWN A LITTLE BIT USING SANDPAPER.  120 GRIT WILL WORK FINE.  YOU CAN SAND BY HAND OR BY USING A BELT SANDER.  IF YOU USE A POWER BELT SANDER, FLIP THE SANDER OVER SO THE BELT IS FACING UP.  AS THE SANDER IS RUNNING. SLOWLY AND GENTLY TOUCH THE EDGE OF THE GLASS TO THE BELT, AND SAND A LITTLE FROM ALL THE EDGES.  THIS WILL CUT THE GLASS DOWN SURPRISINGLY FAST.....

When you measure your size, be sure to allow a little space for "wiggle" room.  ie, do not expect a 2" piece of glass to fit into your 2" opening. If you are lucky, it might fit, but more likely you'll need to "adjust" the glass down a smidge by sanding all of the edges with  120 grit sandpaper. Removing just 1/16" from all around will reduce the diameter by 1/8"!.  IF YOU ARE NOT WILLING TO WORK AT THIS SOME, BUY YOUR GLASS ELSEWHERE.R OF THE GLASS BY 1/8".  PRACTICE ON AN OLD JAR FIRST, AND USE GLOVES, EYE PROTECTION AND A FACE MASK. THANKS, FRED FELD

I can combine shipping if you let me know before ordering


Shipping to 48 contiguous states.  Others, please e-mail first.
............, Thanks, Fred Feld







































Continental USA only.  All others, please e-mail for possible extra postage.

Thanks!