No Battery Included! Batteries in pictures are examples only on how to properly wire them inside the pack.

You must purchase you own pair of 12v 17AH batteries with IT screw terminals and install them. It is an easy process. 

Come with charger.



Battery Changing Procedure
  1. Remove 4 screws along bottom and 4 screws along top of case.
  2. Carefully pull cover off as the battery indicator wire is attached. Place cover above unit, wire does not need to be detached.
  3. Stand case module upright and place the 2 batteries side-by-side in front of the case.
  4. Take the jumper wire and washers and screw them into the adjacent negative and positive terminals of the batteries.
  5. Take the 2 black wires on the left side and screw them with the washers on the negative terminal of the left most battery.
  6. Take the 2 red wires on the right side and screw them  with the washers on the positive terminal of the right most battery.
  7. Slide the batteries into the case carefully
  8. Replace the top cover, making sure all the wires are inside the case and none are getting pinched.
  9. Replace the 8 screws in the cover.