Crew Figure Sitting 3D-Printed Figure

Crew Figure posed sitting.

Designed by SparkFrame Studios, this 3D-printed commercial fisherman posed sitting. Printed in PLA, the model offers good detail, though not as sharp as resin prints. Each figure is unpainted, providing an excellent canvas for customization.

Scaling Information

The figures are scaled based on an average height of 5'11" (180 cm)

Please Note: Some models may exhibit minor flashing around the base of the feet and on top of the hat. These imperfections can be easily removed with a craft knife or light sanding. 3D prints are not always flawless and may require some minor cleanup using a hobby knife, files, or sandpaper. Filler can also be used to refine the finish if needed.

Preparation for Painting:

Surface Preparation: Gently remove any flashing with a craft knife or fine-grit sandpaper to smooth the surface.

Priming: Apply a primer to enhance paint adhesion and achieve a smooth finish. Ensure the model is clean and dry before priming.

Painting: Use high-quality acrylic. Applying multiple thin coats yields better results than a single thick coat. Allow each layer to dry completely before applying the next.

Available in multiple scales—please select your preferred size from the options.

Qty = 1 Figure