3D printed Cannon with Carriage in PLA, available in 15–40mm sizes. Sold in pairs. Perfect for model boats, dioramas, railways, and wargaming.

Select the size you require from the drop down menu

1 Pack of 2

Please Note: Some models may exhibit minor flashing around the base of the feet and on top of the hat. These imperfections can be easily removed with a craft knife or light sanding. 3D prints are not always flawless and may require some minor cleanup using a hobby knife, files, or sandpaper. Filler can also be used to refine the finish if needed.

Preparation for Painting:

Surface Preparation: Gently remove any flashing with a craft knife or fine-grit sandpaper to smooth the surface.

Priming: Apply a primer to enhance paint adhesion and achieve a smooth finish. Ensure the model is clean and dry before priming.

Painting: Use high-quality acrylic. Applying multiple thin coats yields better results than a single thick coat. Allow each layer to dry completely before applying the next.

⚠️ Safety Notice: This is not a toy. Contains small parts and presents a choking hazard. Not suitable for children under 14 years. Intended for use in scale modeling, wargaming, railways, and diorama building by hobbyists.