New!! For 2" lift (Black Paint Finish) with
2" tall x 3" wide glass reinforced nylon blocks
capable of holding 60,000 lbs.
has brackets to lower fan shroud!
1966-77 Ford Bronco body mount hardware and 2 inch lift blocks. This is as close to stock as you can get
but with 1/2" zinc tap bolts (not 3/8" like some other kits). Works with rubber or urethane bushings.
Some other kits use thin 2" fender washers, our top and bottom round pieces measure 2 5/8 x 11 gauge. The square bottom pieces are 2 1/4x 3 inches and are also 11gauge. The bottom square pieces fit in the tabs on the frame so you don't have to hold them with a wrench when you tighten them.
The bottoms interlock with the top pieces.
(((( This hardware is for 2" lift, bolts are 2" longer than our stock kit.))))
1/2 inch zinc tap bolts!! Does not include rubber or urethane.