A non-combustible premium fire cement / putty for bonding low porosity surfaces and for general sealing and repairing work where high temperature resistance up to 1250°C is required.
Used in the construction, installation and repair of Fires, Stoves and Fireplaces it will comply with BS476 Part 4.
For use on solid fuel and gas/oil appliances. eg: wood stoves, gas coal effect fires, oil boiler and any solid fuel appliances.
ROHS Compliant
Thoroughly clean and degrease all surfaces to be bonded or sealed
A light surface abrasion of the material to be bonded will increase the surface area available for adhesion and improve mechanical key Apply the Fire Cement as supplied to all surfaces to be bonded and complete tooling within 5-10 minutes.
Clean any spillages immediately Apply moderate pressure to ensure even anchorage and solid contact of the surfaces to be bonded, so that all surfaces are fully wetted. Secure components and allow the Fire Cement to set.
All application equipment should be cleaned with warm water immediately after application. As this product is water based, it is necessary to fully dry and dehydrate the adhesive. The curing of this product may vary depending on temperature, humidity, porosity of substrates, volume of adhesive and area etc.
A rough guide for typical applications at room temperature and average humidity would be approximately 36-48 hours. Curing may be accelerated by the application of gentle and progressive heat (do not exceed 100 degrees during curing as this may lead to product failure).
The cured product may be removed using steam/ boiling water (high pH will also aid removal).
Please check out our other items and if you have any questions then please don't hesitate to contact us via email or over the phone (01726 860033)
We can also take payment over the phone if required or pop in and see us at unit 9, Victoria gardens, St Columb road, Cornwall, TR9 6QR