Micromotor.eu MMA01 Coreless Motor Replaces Mashima 1620 Round Can Motor

Contents Include:

Coreless Motor

x3 Shaft Adapters

Original Mashima Dimensions

Mashima

Length 26.5mm

Width 16mm

Voltage 12 Volt

Rated speed 14200 RPM

Coreless Micromotor Kit

Voltage 12 Volt

No load speed 15000 RPM

Rated speed 14200 RPM

No load current

Rated current 283 mA

Stall Current 1,6 A

Rated torque 17,3 g.cm

Stall torque 115 g.cm

Micromotor Products Are Designed With a -0.0 + 0.05 mm Tolerance To Be Glue Fitted NOT Friction Fitted.

Recommended Is: Loctite 603 Retaining Compound.

Fitting Instructions Are Via Micromotor Youtube Channel.

(Pictured Locomotive Example (s) Are NOT Included.)

Coreless Motor Information:

Guarantee for 1 year

Do not use with feedback controllers.

Do not use with an analogue low frequency PWM ( Pulse Width Modulation ) Controllers. i.e. H&M Half Wave.

DCC Frequency to at least 16 kHz (Preferred 32 kHz or higher) using the recommended correct coreless motor settings AS ADVISED by the manufacturer of the decoder.

Maximum settings of slow speed starting it is recommended to use the correct coreless motor settings AS ADVISED by the manufacturer of the decoder.

Don’t remove the old capacitor over the motor as the high peaks that the decoder provides on slow running speeds (when it has some resistance) causes a motor coil to burn out and in a lot of cases also a burn out of the decoder.