IMPORTANT CUSTOMER NOTICE:

The elastic has been Threadlocked using "Pyrm Fray Check" fabric glue at each end to prevent fraying of the fabric, if you cut down the fabric to make the arm band shorter you WILL need to super glue the ends again. It is possible to use the flame/candle trick but this may leave burn marks on the fabric.

Example below:

This is a 3D Printed product and has been though many refinements over the last few months, I am now happy to bring my Omni Pod holder to you! It is designed to protect your attached sensor and make it less likely that a knock will dislodge it. It is great to use it when moisture or contact may make the sensor come loose.

Designed and worn by a type 1 diabetic.

My Omni Pod holder will come assembled, you are required to make a few adjustments so it sits well on the arm, i wouldn't recommend putting it on to tight. If you plan to go swimming or doing extreme exercise, i recommend buying more then 1, see below for extra discount if you order more then 1 holder. At least you can wash one while wearing the other.

This Holder has been printed using a industry standard 3D printer to the highest level of quality, it is extremely durable and hard to break, hoping to give you long usage before needing to be replaced. Each Holder takes 1 hour and 9 mins on the print bed. a longer print time means better adhesion meaning a stronger product.

I can not stress enough how comfortable this is I am using a unique elastic which does not irritate the skin.

Mix and Match and get up to 20% on your total order.

10% off when you buy 2 15% off when you buy 3 20% off when you buy 4

If you find you have a lot of excess strap after you have adjusted it you can cut the excess off and seal the edge with flame.

If you any questions please don't hesitate to ask.

PLEASE NOTE: Colour of holder and fabric may slightly vary.