Enhance your PC cooling with a three-pack of Lian Li Fan Shrouds. The custom design concentrates cooler air from outside your PC case and bypasses hot air generated by the hard drives, motherboard and other components in the rear chamber.

As a result, you may see a reduced temperature in the main chamber. The same principle applies when venting air out of your case. The fan shrouds can help remove the hot air faster and separate it from the secondary chamber.

My 120mm fan shroud has been designed to accommodate standard 120x120x25mm PC fans, with said fans mounted inside the main chamber on the side intake. The same applies if screwing into a radiator.

Each fan shroud is carefully 3D printed with high quality filaments using one of three carefully calibrated 3D printers. Layer lines are a normal part of the process, as seen in the photos.

Though the standard PETG material is strong and temperature resistant, PETG carbon fibre is even better in all areas and has a matte black finish. Polycarbonate (PC) filament is even better again, resisting temperatures beyond 100° Celsius (212 Fahrenheit).

Included
3 x 120mm fan shrouds for Lian Li PC case
12 x M5 fan screws / 12 x 6-32mm radiator screw
Temperature resistant PETG material
Fan shroud dimensions: 120 x 120 x 42mm

Not included
3 x 120mm fans
1 x Lian Li PC case

The default depth (pictured) is for the Lian Li Dynamic Evo XL case. Please message me for a custom length to fit the Lian Li O11D, O11D XL, 011D, O11D Evo and 011 Vision.

Other case brands such as Antec, Corsair, NZXT and Phanteks could also be accommodated, as well as custom colours. Details available upon request.

Please note: 140mm fans will not fit. 120mm fans beyond the usual 25mm thickness should be fine with the 'M5 fan screw' option, however, the optional 'radiator 32mm' screws will likely be too short.