Please contract us firstly if there are any problems when you received the package. We will definitely give you satisfying solution, please don't leave neutral or negative feedback without any communication.

For Corvette C8 Front Strut Tower Covers

Whether you know it or not, there is an issue with the all new 2020 for Corvette C8 that allows water to pool in the front strut towers. The towers are made from aluminum but the strut hardware isn’t and the pooling water causes the top nut and bolt to rust. Our for Corvette C8 Strut Tower Covers provides a simple solution and prevents the water from entering the strut towers. Our covers are made from durable black ABS plastic and look like a factory piece once installed. Installation of our for Corvette  C8 Strut Tower Covers can be accomplished in less than 30 minutes with minimal tools.

Customers with front lift adjustable height option (Option code E60): for Chevrolet recently issued a technical service bulletin regarding the reservoir cap leaking. The DOT 4 brake fluid used in the front lift system can have a negative reaction with the chemicals that are in the ABS plastic. It has been described to cause “catalytic embrittlement in the ABS, making it very brittle and weak”. While ABS plastic is normally very durable this chemical reaction with the brake fluid can cause the cover to break.

Please ensure that your reservoir cap is not leaking fluid prior to installation of the passenger side strut tower cover.

Strut Tower Cover Product Installation Step
Please note：Prepare Tools required before installation
pry tool；
10mm socket
wire cutters
zip-tie

How to install (Installation Step)

Please contact us if you need to install the video

1.Use the Pry tool or your hand to eject the side covers and the large center cover.Make them heid on and pull upward to remove them.
NOTE:(When you replace the shock tower cover,please check whether there is water collect in strut mounts,if yes,use a hair dryer or cleaning cloths to soak up the water.)

2.Slide driver side under first:
①Pull the wire harness out of the way from the driver's side strut tower using a pry tool,make sure that the wire harness is behind the shock tower cover when install it.
②Remove the bolt from the side of the coolant reservoir with 10mm socket
③Take out strut tower cover and insert it into the tab between the strut tower and the reservoir.And tighten the bolt with 10mm socket.

3.Then install passenger side:
①Slide the passenger side strut cover into place by angling the cover towards the outer fender then rotating it into place.(Be careful not to bend or damage the hard line or coolant reservoir!)
②Used a zip-tie and funneled it through the screw hole on the cover and tied it along side a tube which was mounted on the car.(Ensure the zip tie is around the rubber isolator.)

4.Reinstall the center and side covers and the job is DONE.

NOTE:The installation steps for Mag Ride and NON-Mag Ride are the SAME