E-Tech Red Engine Enamel Spray On Heat Resistant High Temp Paint 400ml

E-TECH Engine enamel is a high quality, long lasting, enamel coating specially formulated with a ceramic resin to cope with temperatures of up to 250°C, and is suitable for use on most engine parts and components.

Ideal for engine blocks, valve/rocker covers and gearbox/differential casings, plus other engine bay components.

The spray-on application is simple to apply, quick drying and provides a hard, chip resistant, long lasting finish which will retain its colour due to the high pigment content.

Features

• Long lasting high quality finish.
• Tough chip and crack resistant formula.
• Resists oil, engine additives, chemicals, road salt & weathering.
• Excellent durability.
• No primer needed - strong adhesion to bare steel and metal.
• Colour : Red.

Can Size 400ml 

It is a spray on application so quick drying and provides a hard, chip resistant, long lasting finish which retains its colour due to the high pigment content.

Long term performance of this paint on aluminium and stainless steel surfaces cannot be guaranteed.

Not suitable for brass and other non-ferrous metals.

IMPORTANT:

• For best results ensure the engine or part you are painting, and the paint are at room temperature before use (approx 17°C to 21°C).
• For best results apply in a warm, dry and dust free area.
• Use a steel brush to remove loose dirt and rust deposits from surface to be painted.
• Then clean the area to be painted thoroughly with a degreaser or steam cleaner, removing all traces of silicone, oil, dirt, grease etc.
• Mask off any area that you do not want to be painted.
• The area to be painted mst be completely dry and thoroughly clean before you start.

APPLICATION

• Shake can vigorously for a minimum of 2 minutes before use.
• Hold can 20-30cm (8-12") from surface and spray using a smooth side to side motion.
• Build up layers with several thin coats allowing approximately 15-20 minutes between coats for the surface to dry to a tacky film (do not apply heavy coats).
• Shake can between coats.
• After applying the final coat allow 4 hours for the enamel to dry properly.