Matt Finish Patterned Imprinted Concrete Sealer for Driveways and Patios. A hard wearing imprinted concrete sealer with a Matt look finish Our matt finish Imprinted Concrete Sealer has been specially formulated to help with re-colouring and re-sealing of imprinted concrete driveways and patios. It will also help restore the original colouring of the surface of stamped or pressed concrete. It is non-yellowing and has an excellent resistance to water, alkalis and acids. It also contains a UV absorber to improve protection from ultra-violet light and prevent colour loss.
Deicing salts should not be applied directly on Smartseal block paving or concrete sealers. Salt chemically reduces the temperature at which water freezes and will result in water ingress into the concrete. Subsequent freezing may result in the concrete seal being broken by the expansion of water as it freezes and white pitted areas may become visible.
- Protects the surface from oil and other staining.
- Seals, protects and enhances the surface of all pattern imprinted concrete.
- Easily applied by sprayer or broom.
- Protects against colour loss and surface wear.
- Average coverage: 4 to 5 m² per litre (dependent on condition).
- Make sure before applying that the surface temperature is between 10 - 20°C
- Can be combined with Smartseal colour tints to restore original colour of paving
- Smartseal 'Anti-Slip Additive' can be added for extra surface grip
- Hardens & seals concrete permanently
- Non-remulsifiable, non-blooming when wet
- Tough, Durable and Hard Wearing
- Designed for use with Pattern Imprinted Concrete
- Petrol, Diesel, Oil & Grease resistant
Application Guidelines:
- Make sure that surface area is completely clean.
- Make sure that the surface area is bone dry (allow 3-4 dry days after cleaning)
- The Imprinted Concrete Sealer is commonly a 2 coat application, however due to age and condition of the surface, this may vary to get a 'uniform' finish. Please contact us providing pictures if unsure. Furthermore, samples are available to try on a test area.
- Apply sealer to the surface using a broom or sprayer. (allow 1-2 hours minimum between coats).
- Allow 4 hours before walking and 24 hours before any vehicle traffic on the surface (for the sealer to cure and bond to the concrete).
Application
The imprinted concrete slab must be fully surface dry after washing the paving off by pressure washing. Brush slab to remove any dirt or debris. Must be applied via a paving sprayer or soft broom normally in two equal applications, keeping the paving sprayer head moving to avoid pooling. The first application must be brushed into the surface and allowed to dry past tacky prior to applying the second coat of sealer onto the paving. Avoid application in strong, direct sunlight - do not apply if rain is likely within 6 hours of application.Deicing salts should not be applied directly on Smartseal block paving or concrete sealers. Salt chemically reduces the temperature at which water freezes and will result in water ingress into the concrete. Subsequent freezing may result in the concrete seal being broken by the expansion of water as it freezes and white pitted areas may become visible.
