Model: non-slip rubber ring

Adaptation: 8 inch/9 inch/10 inch/12 inch/14 inch/16 inch band saw

Width: 1.1cm---3.5cm

Diameter: 205mm---380mm

Material: Polyethylene

How to use: The principle of thermal expansion and cold contraction, soak it in hot water first, and then stretch it evenly. It is recommended to pin it with a cylindrical object and stretch it evenly, the effect is better.

Packing: 2pcs

hint:

1. Reminders to all buyers:

The apron model represents the true diameter of the applicable band saw wheel. For example, RBS205 means that it is suitable for a band saw wheel with a diameter of 205 mm. Of course, it can be slightly larger or smaller.

2. How to use the apron:

It is best to soak the apron in hot water for even stretching. This allows thermal expansion and contraction, remember to stretch evenly. The best stretching method is to put it on a pillar and pull it evenly. The other method is to step on it with your feet and pull it hard with your hands while stretching in circles. Finally, pin it on with a screwdriver, the rubber ring looks

It is very small and not very elastic; in fact, it just feels like the apron can be put on completely (because the apron is too large and it will loosen when used).

3. Precautions:

When installing the rubber ring, be sure to remove the band saw guide wheel first. Then according to method 2, after soaking in hot water, install it vertically and evenly.